Nitrogen Oxide Sensor (Exhaust Outlet) - Remove and Install
Show/hide table
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 468-8116 | Socket | 1 |
Note: Refer to Special Instruction, REHS8151, "NOx Sensors Handling and Installation Procedures" for additional information when removing and installing nitrogen oxide sensors.
- Remove bolts (1) and cover (2).
Show/hide table
Illustration 2 g06317795 - Disconnect harness assemblies (7). Remove clamps (3) and cable straps (4).
- Remove bolts (5). Use Tooling (A) to remove nitrogen oxide sensors (6).
Show/hide table
| |
| Illustration 1 | g06317703 |
- Install nitrogen oxide sensors (6) in the reverse order of removal.
- Tighten nitrogen oxide sensors (6) to a torque of
50 ± 10 N·m (37 ± 7 lb ft) .
- Tighten nitrogen oxide sensors (6) to a torque of
Caterpillar Information System:
320D3 Hydraulic Excavator Machine Systems Swivel - Assemble
320D3 Hydraulic Excavator Machine Systems Swivel - Disassemble
320D3 Excavators Maintenance Interval Schedule
320D3 Excavators Fuel Lift Pump Strainer - Replace
320D3 Excavators Hydraulic System Oil Filter (Pilot) - Replace
320D3 Excavators Hydraulic System Oil Filter (Case Drain) - Replace
320D3 Excavators Fuel System Water Separator - Drain
320D3 Excavators Fuel System Secondary Filter - Replace
320D3 Excavators Fuel System Primary Filter (Water Separator) Element - Replace
797F Tier 4 Off-Highway Truck Engine Supplement Voltage Control (Load Protection) - Remove and Install
320D3 and 323D3 Excavators Systems Main Electrical System
320D3 Hydraulic Excavator Machine Systems Heating and Air Conditioning Unit - Remove and Install
C175 Tier 4 Final Engines for Caterpillar Built Machines Water Pump - Assemble
Engine Storage and Engine Start-Up After Storage {1000, 1300, 1348, 7418} Engine Storage and Engine Start-Up After Storage {1000, 1300, 1348, 7418}
301.5, 301.6, 301.7 CR, 301.8 and 302 CR Mini Hydraulic Excavators Quick Coupler Operation - If Equipped
C18 Generator set and C18 Marine Engines Fuel Filter Base - Remove and Install
The Hydraulic Tank is Improved on Certain 797F Off-Highway Trucks {5056} The Hydraulic Tank is Improved on Certain 797F Off-Highway Trucks {5056}
797F Tier 4 Off-Highway Truck Engine Supplement Nitrogen Oxide Sensor (Exhaust Inlet) - Remove and Install
The Brake Cooling and Brake Charging Pump May Lose Efficiency Prematurely on Certain 777G Off-Highway Trucks {5073} The Brake Cooling and Brake Charging Pump May Lose Efficiency Prematurely on Certain 777G Off-Highway Trucks {5073}
301.5, 301.6, 301.7 CR, 301.8 and 302 CR Mini Hydraulic Excavators Boom/Stick/Bucket Combinations
320D3 and 323D3 Excavators Systems Pump Control (Main Hydraulic) - Main Pump Regulator
C18 Generator set and C18 Marine Engines Fuel Manifold - Remove
320D3 Hydraulic Excavator Machine Systems Monitor - Remove and Install - Machine
320 D3 Hydraulic Excavators Engine Disassembly and Assembly Crankshaft Front Seal - Remove and Install