Selective Catalytic Reduction Retrofit Aftertreatment - Airless Dosing Caterpillar


DEF Tank Temperature Is Low

Usage:

SCR PF3
Use this procedure to troubleshoot a low Diesel Exhaust Fluid (DEF) tank temperature. Also, use this procedure if one of the following event codes is active or logged.

Table 1
J1939 Code and Description  CDL Code and Description  Comments 
4368-18
Aftertreatment #1 DEF Tank #2 Temperature : Low - moderate severity (2) 
E1399 (2)
Low Aftertreatment #1 DEF Tank #2 Temperature 
The DEF tank temperature is low. 

Table 2
Associated Codes 
J1939 Code  CDL Code  Troubleshooting Procedure 
4368-3  3135-3  Troubleshooting, "DEF Tank Sensor - Test" 
4368-4  3135-4  Troubleshooting, "DEF Tank Sensor - Test" 

Probable Causes

  • Codes

  • Sensor

Recommended Actions

Table 3
Troubleshooting Test Steps  Values  Results 

1. Check for Codes

A. Turn the breaker to the ON position.

B. Connect Cat® Electronic Technician (ET) to the service tool connector.

C. Look for active codes that are associated with the system for the event code.
 

Codes
 

Result: An associated code is active.

Repair: Troubleshoot any associated codes before continuing with this test.

Result: A code is active or logged.

Proceed to Test Step 2.
 

2. Check the DEF Tank #2 Temperature Sensor

A. Turn the breaker to the ON position.

B. Connect Cat ET.

C. Use Cat ET to monitor the following temperature:

- "Cabinet Temperature"
- "DEF Tank #2 Temperature"
 

Sensor
 

Result: The "DEF Tank #2 Temperature" is within 5° C (9° F) of the "Cabinet Temperature".

Repair:The DEF Tank temperature is too low. Contact your TC for assistance.

Result: The "DEF Tank #2 Temperature" is not within 5° C (9° F) of the "Cabinet Temperature".

Repair: A failed DEF tank temperature sensor has been detected. Replace the DEF header assembly.

Verify that the repair eliminated the problem.
 

If the procedure did not correct the issue, contact your Cat dealer Technical Communicator (TC). For further assistance, your TC can confer with the Dealer Solutions Network (DSN).

Caterpillar Information System:

C32 Tier 4 Final Marine Commercial Engines Crankcase Pressure Is High
Selective Catalytic Reduction Retrofit Aftertreatment - Airless Dosing DEF Tank Temperature Is High
Selective Catalytic Reduction Retrofit Aftertreatment - Airless Dosing DEF Tank Level Is High
XGC1900 Generator Sets Coolant Level - Check
3512E Land Electric Drive Engine Valve Lash - Check
320GC, 320 and 323 Excavators Machine Systems Bucket Linkage Bearings and Seals - Remove and Install
320GC, 320 and 323 Excavators Machine Systems Swing Gear and Bearing - Install
New Software is Used for Certain G3516 Engines {7620, 775E} New Software is Used for Certain G3516 Engines {7620, 775E}
New Ball Valve is Now Used on Certain Cat® Products {1380, 7542} New Ball Valve is Now Used on Certain Cat® Products {1380, 7542}
C9.3 Marine Auxiliary and Generator Set Engine Fuel Filter Is Restricted
C9.3 Marine Auxiliary and Generator Set Engine Fuel Pressure Is Low
C9.3 Marine Propulsion Engine Sensor Supply - Test
C27 and C32 Engine for MD6250 and MD6310 Drill Engine Misfires, Runs Rough or Is Unstable
XGC1900 Generator Sets Model View Illustrations
C280-16 Marine Propulsion Engine Sensor Signal (Analog, Active) - Test
Selective Catalytic Reduction Retrofit Aftertreatment - Airless Dosing SCR Catalyst Inlet Pressure Is High
Selective Catalytic Reduction Retrofit Aftertreatment - Airless Dosing SCR Catalyst Inlet Pressure Is Low
3516E Generator Set Engines Cylinder Head
3516B Generator Set Engines with Dynamic Gas Blending Gas Substitution Percentage Is Low
3516B Generator Set Engines with Dynamic Gas Blending Air Shutoff - Test - No Codes
The Hour Meter On Certain Telehandlers, Industrial Engines,and Paving Compactorswith the C3.4B Engine Cannot Be Changed Using Caterpillar Electronic Technician Service Tool {7451} The Hour Meter On Certain Telehandlers, Industrial Engines,and Paving Compactorswith the C3.4B Engine Cannot Be Changed Using Caterpillar Electronic Technician Service Tool {7451}
3500 Generator Sets with Dynamic Gas Blending Overhaul (Top End)
3516B Generator Set Engines with Dynamic Gas Blending Fuel Pressure - Diesel System
Replacement Solenoid Valves May Fail on Certain Transmissions {3073, 3167, 3174, 5479, 7499} Replacement Solenoid Valves May Fail on Certain Transmissions {3073, 3167, 3174, 5479, 7499}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.