CN1566, CN2086, CN2586, CN3086, CN3586, CN4086 and CN5086 Electric Motors Caterpillar


Space Heater - Inspect/Replace

Usage:

CN1566 RJ3
如有必要,请参照以下步骤正确更换空间加热器。

  1. 锁定所有电气和机械能源。 确保空间加热器的电压源锁定。 使用电压表来确认没有电压。


    图 1g06148896
    检修板位置
    (1) 空间加热器检修板
    (2) 空间加热器接线盒检修板(大型装置)

  2. 找到空间加热器的检修板。

    注: 在大型装置上,空间加热器位于空间加热器接线盒的安装板后面。



    图 2g06146437
    拆下检修板

  3. 拆下将板固定到机架上的四个螺栓。


    图 3g06146439
    加热器固定到板上

  4. 小心地拆下板。 在板的后部有一个延伸到电机机架内的支架。 加热器固定到板的内侧。

  5. 断开空间加热器和接线盒之间的接线。


    图 4g06146446
    从支架上拆下空间加热器

  6. 从支架上拆下空间加热器。 使用内六角扳手或六角扳手松开螺栓。

    注: 空间加热器位于连接到板背面的支架上。

  7. 将新的空间加热器安装到支架上。

  8. 将所有接线重新连接到新的空间加热器。

    注: 注意导线的布线。 不要拉紧或挤压任何导线。

  9. 将空间加热器插回电机机架内。 确保在安装板时不要夹住导线。

  10. 重新安装并拧紧固定螺栓,将板安装到机架上。

Caterpillar Information System:

C7.1 Engines and Generator Sets Sensor Supply - Test
C7.1 Engines and Generator Sets Sensor Signal (Analog, Passive) - Test
C32 Marine Auxiliary Engine On-Board Replacement Parts
New Plate Assemblies Are Now Used on Certain Cat® Engines {1379} New Plate Assemblies Are Now Used on Certain Cat® Engines {1379}
Procedure to Install SOLAS Tape On Certain 3516B Engines Fuel Rails {1252, 1274, 1702} Procedure to Install SOLAS Tape On Certain 3516B Engines Fuel Rails {1252, 1274, 1702}
C7.1 Engines and Generator Sets Sensor Signal (Analog, Active) - Test
C7.1 Engines and Generator Sets Sensor Calibration Required - Test
New Engine Software for Certain C4.4 Generator Sets {108F, 1920} New Engine Software for Certain C4.4 Generator Sets {108F, 1920}
C7.1 Engines and Generator Sets Relay - Test - Fuel Transfer Pump Relay
C7.1 Engines and Generator Sets Power Take-Off - Test
Diesel Exhaust Fluid Quality Sensor Updates on C9.3 - C18 Tier 4 Final Engines {108U, 1920} Diesel Exhaust Fluid Quality Sensor Updates on C9.3 - C18 Tier 4 Final Engines {108U, 1920}
Procedure for Proper Sealing of the Swing Drive and Final Drive on All Excavators {4050} Procedure for Proper Sealing of the Swing Drive and Final Drive on All Excavators {4050}
C32 Marine Auxiliary Engine Customer Assistance
An Improved Water Lines Group Is Now Used on Certain C175-16 Locomotive Engines {1380} An Improved Water Lines Group Is Now Used on Certain C175-16 Locomotive Engines {1380}
C7.1 Engines and Generator Sets Shutdown (Ground Level) - Test
C7.1 Engines and Generator Sets Solenoid Valve - Test
G3516 Petroleum Engine Plate Locations and Film Locations
New Software Is Now Used for Certain 3412 Electric Power Application Engines {1920} New Software Is Now Used for Certain 3412 Electric Power Application Engines {1920}
C4.4 Generator Sets Voltage Regulators
G3516 Petroleum Engine Product Storage
3512E and 3516E Marine Engines Catalyst (SCR) - Remove and Install
C7.1 Engines and Generator Sets Soot Sensor - Test
C7.1 Engines and Generator Sets Speed Control (Analog) - Test
C7.1 Engines and Generator Sets Speed Control (PWM) - Test
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.