Track Roller (Single Flange)
Show/hide table
Illustration 1 | g06010401 |
Typical example |
Show/hide table
Item | Qty | Part | Specification Description |
---|---|---|---|
1 | - | - | Before assembly, the surfaces must be clean and free of protective coating. |
2 | 2 | 8F-8882 O-Ring Seal | Lubricate the bore lightly with the lubricant that is being sealed. |
3 | 2 | Bushing | Bore after assembly is |
4 | 1 | 9W-2146 Plug | Before assembly, apply blue Loctite 243 to threads.
Torque to |
5 | 2 | - | The rubber toric seals and all the contacting surfaces must be clean and dry at assembly. Before assembly, apply a thin film of 6V-4876 Lubricant to the contacting surfaces of the metal seal rings. The seal rings must be assembled square. The rubber toric seal should not bulge and the rubber toric seal should not twist. |
- | - | - | End play for the track roller shaft:
Minimum is Maximum is |
Caterpillar Information System:
G3516 TA Engine Sensor Supply - Test
G3516 TA Engine Sensor Signal (Analog, Passive) - Test
Cat® Command For Hauling MID 039 - CID 0838 - FMI 21
Cat® Command For Hauling MID 039 - CID 0839 - FMI 21
Cat® Command For Hauling MID 039 - CID 0840 - FMI 21
Cat® Command For Hauling MID 039 - CID 0841 - FMI 21
Cat® Command For Hauling MID 039 - CID 0841 - FMI 04
Cat® Command For Hauling MID 039 - CID 0840 - FMI 04
Cat® Command For Hauling MID 039 - CID 0839 - FMI 04
C175-16 Locomotive Engine SCR Catalyst Inlet Pressure Is Low
C18 Generator Set Engines Fuel Manifold (ARD) - Remove and Install
G3516 TA Engine Sensor Signal (Analog, Active) - Test
C12.9 Marine Engines Fumes Disposal Filter Element - Replace - Internal/Centrifugal
New Spring Assemblies Are Now Used On Certain C4.4 Generator Sets {7274} New Spring Assemblies Are Now Used On Certain C4.4 Generator Sets {7274}
New Oil Pressure Sensor Is Now Used on Certain GEN SETCat Products {1924, 4490} New Oil Pressure Sensor Is Now Used on Certain GEN SETCat Products {1924, 4490}
C175-20 Locomotive Engine DEF Tank Sensor - Test
G3500J Petroleum Engines Exhaust Manifold
C175-16 Locomotive Engine NOx Conversion Is Low
C175-16 Locomotive Engine SCR Catalyst Temperature Sensor - Test
CG137-08 and CG137-12 Engines Catalytic Converter Pressure - Test - If Equipped
C175-16 Locomotive Engine Speed Control - Test
CG137-08 and CG137-12 Engines Catalytic Converter Substrate - Inspect - If Equipped
CG137-08 and CG137-12 Engines Catalytic Converter Substrate - Replace - If Equipped
C175-16 Locomotive Engine Sensor (Data Link Type) - Test