Rocker Shaft and Push Rod - Remove
Start By:
- Remove the valve cover and the spark plug.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
- Remove bolts (1) and remove rocker shaft (2) from the valve cover base.
Note: Place an identification mark on each pushrod in order to identify the proper location in the engine.
- Remove pushrods (3) from the valve lifters.
Show/hide table
Illustration 2 g00759331 - Remove valve bridges (4).
Show/hide table
Illustration 1 | g00759287 |
Caterpillar Information System:
G3508J, G3516J, and G3520J Engines Gear Group (Rear) - Install
G3508J, G3516J, and G3520J Engines Gear Group (Rear) - Remove
G3508J, G3516J, and G3520J Engines Accessory Drive (Front) - Assemble
352F OEM Excavator Based Specialty Solutions Shipping the Machine
G3606 and G3608 Engines Fuel Shutoff Solenoid - Remove and Install
C3.3B and C3.8 Engines for Caterpillar Built Machines NOx Conversion Is Low
3516E Generator Set Engine Fuel Pressure
349F and 352F Excavators Selective Catalytic Reduction Warning System
3516E Generator Set Engine Electronic Control Module (ECM)
SRMP Electric Power Generation SRMP Generator Coupling - Remove and Install
794 AC Off-Highway Truck Machine Systems Steering Control Valve - Remove and Install
Improvements to the Main Hydraulic Pump are Now Used on Certain Excavators and Mobile Hydraulic Power Units {5070} Improvements to the Main Hydraulic Pump are Now Used on Certain Excavators and Mobile Hydraulic Power Units {5070}
C280-16 Tier 4 Marine Engine and C280-12 Tier 4 Marine Engine Exhaust Manifold Shield - Remove and Install
G3508J, G3516J, and G3520J Engines Rocker Shaft and Push Rod - Install
G3508J, G3516J, and G3520J Engines Cylinder Head - Remove
G3508J, G3516J, and G3520J Engines Cylinder Head - Disassemble
G3508J, G3516J, and G3520J Engines Cylinder Head - Assemble
G3508J, G3516J, and G3520J Engines Cylinder Head - Install
G3508J, G3516J, and G3520J Engines Piston Cooling Jets - Remove and Install
G3508J, G3516J, and G3520J Engines Connecting Rod Bearings - Remove and Install
G3508J, G3516J, and G3520J Engines Piston and Connecting Rods - Remove
G3508J, G3516J, and G3520J Engines Piston and Connecting Rods - Install
794 AC Off-Highway Truck Machine Systems Blower Fan - Remove and Install
XQ2000 Power Module Welding on Engines with Electronic Controls