Housing (Front) - Remove and Install
Removal Procedure
Show/hide table
Tool     | Part Number     | Part Description     | Qty     |
A     | −     | Loctite 593     | 1     |
Start By:
- Remove the vibration damper.
- Remove the crankshaft front seal.
- Remove bolts (1) that connect oil pan to front housing.
Show/hide table
Illustration 1 | g03851679 |
- Remove bolts (2) and front housing (3) .
Note: Use caution when removing front housing (3) so oil pan gasket does not get damaged.
Show/hide table
Illustration 2 | g03851688 |
Installation Procedure
- Install front housing (3) in the reverse order of removal.
Note: Install all bolts finger tight first prior to final tightening.
- Apply Tooling (A) in a bead with a width of 1.5 ± 0.3 mm (0.06 ± 0.01 inch)to the joint face. Front housing (3) must be installed within 5 minutes of applying the sealant.
- Tighten bolts (1) to a torque of 46 ± 5N·m (34 ± 3 lb ft)
- Tighten bolts (2) to a torque of 19 ± 3 N·m (168 ± 27 lb in)
Caterpillar Information System:
G3516 Petroleum Engine Product Description
C8.7 Marine Engine Electronic Unit Injector - Remove and Install
G3516 Petroleum Engine Model View Illustrations
G3516 Petroleum Engine Safety Messages
CG137-08 and CG137-12 Engines Parallel Operation
CG137-08 and CG137-12 Engines Single Unit Operation
3512C Generator Set Engine Housing (Front) - Remove and Install
C280-08 Tier 4 Engine Engine Oil Coolers - Assemble
G3516 Petroleum Engine Maintenance Interval Schedule
CG137-08 and CG137-12 Engines Sensors and Electrical Components
CG137-08 and CG137-12 Engines Electronic Modular Control Panel 4 (EMCP 4) - EMCP 4.4
CG137-08 and CG137-12 Engines Product Description
120 and 120 AWD Motor Grader Before Starting Engine
120 and 120 AWD Motor Grader Steering Frame Lock
120 and 120 AWD Motor Grader Articulation Bearings - Lubricate
2015/06/26 Improved Heavy Duty Tier 3 and Tier 4 Injectors Are Now Used on Certain Engines {1251, 1254, 1290, 1713}
2015/07/07 New Thermowell Adapters Are Available for Certain 3500 Tier 2 Marine Engines {1906, 1929, 7498}
New Turbocharger Heat Shields Are Used on Certain 3500 Marine and Petroleum Engines {1073} New Turbocharger Heat Shields Are Used on Certain 3500 Marine and Petroleum Engines {1073}
New Alternator Mounting Group Installation On Certain Electric Power Generation Engines{1405} New Alternator Mounting Group Installation On Certain Electric Power Generation Engines{1405}
2015/08/14 A Connector with a New Cap Is Now Used on the Engine Interface Box for Certain G3500B Engines {1408, 4460, 7426}
C175-16 Locomotive Engine DEF Pump Motor - Test
C175-16 Locomotive Engine DEF Pump Power Supply - Test
G3516 Petroleum Engine Sensors and Electrical Components
C8.7 Marine Engine Pistons and Connecting Rods - Remove and Install