Cylinder Block Cover - Remove and Install
Start By:
- Remove electronic control module.
- Remove oil filter base (if equipped).
- Disconnect tube assembly (1). Remove elbow assembly (2).
- Remove bolt (3) and clip (4).
Show/hide table
Illustration 2 g03835259 - Remove bolts (5), studs (6), and cylinder block cover (7).
Show/hide table
Illustration 3 g03835285 - Remove connector (8) and pressure sensor (9).
- Remove screws (10) and pressure sensor (11).
Show/hide table
Illustration 1 | g03835257 |
- Install cylinder block cover (7) in the reverse order of removal.
- Tighten studs (6) and bolts (5) in numerical sequence shown in illustration 4 to a torque of
28 ± 7 N·m (248 ± 62 lb in) .
Show/hide tableIllustration 4 g03835342 - Tighten studs (6) and bolts (5) in numerical sequence shown in illustration 4 to a torque of
Caterpillar Information System:
3500 Engines Housing (Front)
C2.2 Engines For Caterpillar Built Machines Sensor Signal (Analog, Passive) - Test
3406E Engine Cylinder Head - Install
The Hose and Tube Assembly in the Service Brake Control Group May Fail on Certain 777G Off-Highway Trucks{4257, 4269} The Hose and Tube Assembly in the Service Brake Control Group May Fail on Certain 777G Off-Highway Trucks{4257, 4269}
C27 and C32 Engine for MD6250 and MD6310 Drill Coolant Level - Test
XQC1200 and XQC1600 Power Modules Circuit Breaker Panel - Remove and Install
442-1750 Lifting Plate{0374, 0599, 0629, 0632, 0700, 1122} 442-1750 Lifting Plate{0374, 0599, 0629, 0632, 0700, 1122}
C11, C13, C15, and C18 Industrial Engines NRS Exhaust Gas Temperature Is High
C9.3 Marine Engine Front Cover - Remove and Install
Procedure to Adjust Track Tension on Variable Gauge Undercarriages {4157, 4158} Procedure to Adjust Track Tension on Variable Gauge Undercarriages {4157, 4158}
3512C and 3516C Industrial Engines Engine Oil Cooler Bypass and Cooling Jet Sequence Valves
Thinner Spacer Plates Not Recommended On Certain 3406E Through C18 On-Highway Truck Engines To Resolve Cylinder Liner Projection{1239} Thinner Spacer Plates Not Recommended On Certain 3406E Through C18 On-Highway Truck Engines To Resolve Cylinder Liner Projection{1239}
C9.3 Marine Engine Valve Mechanism Cover - Remove and Install
3600 Distillate Fuel Engines Maintenance Interval Schedule
PM820, PM822, and PM825 Cold Planer Lifting and Tying Down the Machine - Fixed Conveyor
C9.3 Marine Engine Cylinder Head - Remove and Install
3500B High Displacement Locomotive Engines Fuel Injector Mechanism
12M Motor Grader Wheel Lean Bearings - Lubricate
2015/07/07 An Improved Housing for the Throttle Inlet Is Used on Certain G3500 Engines {1071}
3500 Generator Sets with Dynamic Gas Blending Generator Bearing - Inspect
2015/08/14 A New Control Valve Assembly for Fuel Is Used on Certain 3500 Marine Engines {1261}
3500 Generator Sets with Dynamic Gas Blending Generator Bearing - Replace
C9.3 Marine Engine Engine Oil Pan - Remove and Install - Right-Hand Service
C280-08 Tier 4 Engine Exhaust Manifold Shield - Remove and Install