Installation Procedure to Retrofit a 471-1985 Swivel Guard Upgrade Kit on Certain Excavators {7153}
- Excavator
- 315C to 323F Excavators
- 320 GC, 320 and 323 Excavators
Introduction
This Special Instruction outlines the installation procedure for a 471-1985 Swivel Guard Upgrade Kit on certain excavators listed above.
Do not perform any of the procedures or order any parts until you have read and understand the instructions contained in this publication.
Parts List
Show/hide table
471-1985 Swivel Guard Upgrade Kit | |||
Item | Qty | Part Number | Part Name |
1 | 1 | Plate As | |
2 | 1 | Plate As | |
3 | 5 | Locking Bolt | |
4 | 5 | Hard Washer |
Machine Preparation
Show/hide table
Illustration 1 | g02280104 |
Servicing position of an Excavator |
- Place the machine in the servicing position. Refer to the appropriate Operation and Maintenance Manual for the proper procedure.
Installation Procedure
Show/hide table
Illustration 2 | g06243050 |
(1) (2) (3) (4) |
Caterpillar Information System:
C4.4 Engines General Information
3512E Tier 4 Final Engines for Land Electric Drilling Sensor Signal (Analog, Active) - Test
C280-08 Tier 4 Engine Fuel Priming Pump - Remove and Install
3512E Tier 4 Final Engines for Land Electric Drilling Sensor Signal (Analog, Passive) - Test
3512E Tier 4 Final Engines for Land Electric Drilling Coolant Level Is Low
3512E Tier 4 Final Engines for Land Electric Drilling Speed Control - Test
3512, 3508 and 3516 Generator Sets Maintenance Interval Schedule - Standby
Installation Procedure to Retrofit Overhead Guard and Front Window Guard Upgrade Kits on the Cab of Certain Large Excavators and Mobile Hydraulic Power Units {7159} Installation Procedure to Retrofit Overhead Guard and Front Window Guard Upgrade Kits on the Cab of Certain Large Excavators and Mobile Hydraulic Power Units {7159}
3512, 3508 and 3516 Generator Sets Maintenance Interval Schedule - Prime Power
Installation Procedure for the Jacket Water Bypass Tube Bracket on Certain 3512C Engines{1380} Installation Procedure for the Jacket Water Bypass Tube Bracket on Certain 3512C Engines{1380}
C280-16 Tier 4 Marine Engine and C280-12 Tier 4 Marine Engine Turbocharger - Remove and Install
C13 Industrial Engine Intake Manifold Air Pressure Is Low
3500 Generator Sets Maintenance Interval Schedule - Standby
2014/11/14 New EMCP 3.2/3.3 Software Is Now Available For Use On Certain Cat® Products {4490, 7620}
793F Off-Highway Truck Fuel Correction Factor - Set
3500 Generator Sets Maintenance Interval Schedule - Prime Power
3500 Generator Sets Maintenance Interval Schedule - High Displacement
C13 Industrial Engine Exhaust System Contains Oil
C13 Industrial Engine Exhaust Temperature Is High
C13 Industrial Engine Fuel Consumption Is Excessive
C13 Industrial Engine Fuel Pressure Is High
2014/12/19 A New Hazardous Location Customer Connection Harness Is Available for Certain C9, C15, and C32 Commercial Engines {1408, 1900}
C13 Industrial Engine Fuel Temperature Is High
C13 Industrial Engine Idle Speed Is High