Exhaust Bypass - Inspect
For instructions on removal and installation, see the Disassembly and Assembly, "Exhaust Bypass Valve".
Show/hide table
Illustration 1 | g02580817 |
View of the rear of a CG137 Engine (1) Exhaust bypass (2) Breather for the exhaust bypass |
Show/hide table
Illustration 2 | g02580996 |
Exhaust bypass (3) Diaphragm (4) Valve stem |
- Remove the exhaust bypass valve.
Show/hide table
The exhaust bypass valve cover is under spring compression. To prevent personal injury, use caution when removing the cover.
- Disassemble the valve.
- Inspect the diaphragm . If the diaphragm is worn or cracked, replace the diaphragm.
- Inspect the valve stem and the valve guide. If the parts are excessively worn, replace the parts.
- Clean the breather.
- Assemble the valve.
- Install the valve.
- Refer to Special Instructions, REHS6590 for fuel setup instructions to tune settings.
Caterpillar Information System:
XQ400 Power Module Ignition System Timing - Check/Adjust
XQ400 Power Module Carburetor Air/Fuel Ratio - Check/Adjust
G3520H Generator Set Engine Turbocharger - Assemble
C7 and C9 Industrial Engines Injection Actuation Pressure - Test
C280 Marine Engines Exhaust Temperature - Test
XQ400 Power Module Emergency Stopping
XQ400 Power Module Parallel Operation
C7 and C9 Industrial Engines Indicator Lamp - Test
Reuse and Salvage for C4.4, C6.6 & C7.1 Engine Cylinder Blocks {0374, 0599, 0701, 0705, 1200, 1201} Reuse and Salvage for C4.4, C6.6 & C7.1 Engine Cylinder Blocks {0374, 0599, 0701, 0705, 1200, 1201}
CG137-08 and CG137-12 Engines Declaration of Conformity
G3520H Generator Set Engine Turbocharger - Disassemble
C7 and C9 Industrial Engines Ether Starting Aid - Test
CG137-08 and CG137-12 Engines Catalytic Converter Substrate - Inspect
XQ400 Power Module Control Panel - Inspect/Test
XQ400 Power Module Engine Performance - Test
XQ400 Power Module Gas Pressure Regulator - Test
C3.4B Engines Relay - Test - Start Relay
Radiator for C4.4 Marine Generator Set{1353} Radiator for C4.4 Marine Generator Set{1353}
G3512H and G3516H Generator Set Engines Air Inlet Manifold - Remove and Install
DE Series Generator Set With Cat C7.1 Engine Product Description
2014/10/03 Cat® Reman Announces Additional C7 Engine Options for Certain Thomas Built Bus Applications {1000, 1201}
Engine System Setup for Certified CG137-12 Generator Set Engines {1270, 1278} Engine System Setup for Certified CG137-12 Generator Set Engines {1270, 1278}
3500E EPA Tier 4 Final and IMO-II/III Switchable Marine Engines Air Shutoff - Test
DE Series Generator Set With Cat C7.1 Engine Safety Messages