Ignition System Timing - Check/Adjust
Engine timing should be set by following Special Instructions, REHS6590.
A timing calibration must be performed on the engine if the ECM has been replaced and the copy configuration function is not used. Also, the timing must be calibrated if work has been performed on the front gear train of the engine.
The offset is programmed into the electronic control module (ECM) via the Cat Electronic Technician (ET).
An engine speed/timing sensor is used to detect the torque control of the camshaft. The signal is provided to the ECM.
Perform the procedure described in Systems Operation Troubleshooting Testing and Adjusting, KENR9788, "Ignition Timing - Adjust".
Caterpillar Information System:
XQ400 Power Module Carburetor Air/Fuel Ratio - Check/Adjust
G3520H Generator Set Engine Turbocharger - Assemble
C7 and C9 Industrial Engines Injection Actuation Pressure - Test
C280 Marine Engines Exhaust Temperature - Test
XQ400 Power Module Emergency Stopping
XQ400 Power Module Parallel Operation
C7 and C9 Industrial Engines Indicator Lamp - Test
Reuse and Salvage for C4.4, C6.6 & C7.1 Engine Cylinder Blocks {0374, 0599, 0701, 0705, 1200, 1201} Reuse and Salvage for C4.4, C6.6 & C7.1 Engine Cylinder Blocks {0374, 0599, 0701, 0705, 1200, 1201}
CG137-08 and CG137-12 Engines Declaration of Conformity
G3520H Generator Set Engine Turbocharger - Disassemble
C7 and C9 Industrial Engines Ether Starting Aid - Test
C6.6 Generator Sets Maintenance Interval Schedule
XQ400 Power Module Exhaust Bypass - Inspect
CG137-08 and CG137-12 Engines Catalytic Converter Substrate - Inspect
XQ400 Power Module Control Panel - Inspect/Test
XQ400 Power Module Engine Performance - Test
XQ400 Power Module Gas Pressure Regulator - Test
C3.4B Engines Relay - Test - Start Relay
Radiator for C4.4 Marine Generator Set{1353} Radiator for C4.4 Marine Generator Set{1353}
G3512H and G3516H Generator Set Engines Air Inlet Manifold - Remove and Install
DE Series Generator Set With Cat C7.1 Engine Product Description
2014/10/03 Cat® Reman Announces Additional C7 Engine Options for Certain Thomas Built Bus Applications {1000, 1201}
Engine System Setup for Certified CG137-12 Generator Set Engines {1270, 1278} Engine System Setup for Certified CG137-12 Generator Set Engines {1270, 1278}
3500E EPA Tier 4 Final and IMO-II/III Switchable Marine Engines Air Shutoff - Test