CG137-08 and CG137-12 Engines Caterpillar


Refill Capacities

Usage:

CG137-08 FPL
Refer to this Operation and Maintenance Manual, "Fluid Recommendations" for information about the fluids which are acceptable for this engine.

Lubricant Refill Capacity

The capacity of the engine crankcase includes the capacity of the oil filters that are installed at the factory.

Table 1
Refill Capacities for the Lubrication System (1)    
Sales Model     CG137-12    
Lubrication system    
170 L (45 US gal)    
( 1 ) Engine crankcase including standard filters

Coolant Refill Capacity

To maintain the cooling system properly, the total cooling system capacity must be determined. Refer to the specifications that are provided by Caterpillar or by the OEM of the equipment. Record the total cooling system capacity in the table 2:

Table 2
Refill Capacities for the Cooling System    
Sales Model     CG137-12    
Engine only    
75 L (20 US gal)    
Radiator only        
Total cooling system        

Caterpillar Information System:

XQ400 Power Module Before Starting Engine
CG137-12 Generator Set Sensors and Electrical Components
XQ400 Power Module Electronic Modular Control Panel 4 (EMCP 4) - EMCP 4.4
XQ400 Power Module Alarms and Shutoffs
CG137-08 and CG137-12 Engines Plate Locations and Film Locations
C7 and C9 Industrial Engines Engine Cranks but Does Not Start
C15 and C18 Engines for Caterpillar Built Machines ECM Does Not Communicate with Other Modules
C7 and C9 Industrial Engines Cylinder Is Noisy
C7 and C9 Industrial Engines Oil Consumption Is Excessive
XQ400 Power Module Product Description
C18 Marine Engine Maintenance Interval Schedule
C18 Marine Engine Additional Messages
XQ400 Power Module Fluid Recommendations
CG137-12 Generator Set Maintenance Interval Schedule
C175-16 PETROLEUM ENGINES Fuel Priming Pump - Remove and Install
C7 and C9 Industrial Engines Engine Has Mechanical Noise (Knock)
C7 and C9 Industrial Engines Air Shutoff - Test
C4.4 Engines Valve Position - Test
C4.4 and C7.1 Engines Water in Fuel - Test
C4.4 Engines for Caterpillar Built Machines Temperature Sensor (Catalyst Inlet) - Remove and Install
C3.4B Engines NOx Sensor - Test
C4.4 Engines for Caterpillar Built Machines Ammonia Sensor - Remove and Install - Ammonia Sensor if Equipped
C4.4 Engines for Caterpillar Built Machines Temperature Sensor (Exhaust) - Remove and Install - Selective Catalytic Reduction (SCR) Temperature Sensor
Cat® Reman Injectors with Invalid Injector Trim Files {1290} Cat® Reman Injectors with Invalid Injector Trim Files {1290}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.