C175-16 PETROLEUM ENGINES Caterpillar


Fuel Priming Pump - Remove and Install

Usage:

C175-16 P6L

拆卸步骤


    注意

    在检查、保养、测试、调整及维修产品时,请小心确保盛接油液。 在打开任何舱室或拆卸任何含有油液的部件前,请准备好盛接液体用的适当容器。



    注意

    保持所有零件清洁无杂质。

    杂质会造成快速磨损並縮短部件使用寿命。


  1. 将燃油供应转到断开位置。


    图 1g03728882

  2. 断开软管组件 (2) 和 (3)。

  3. 拆下螺栓 (1 )。

  4. 拆卸燃油注油泵 (4)。

安装步骤


    注意

    保持所有零件清洁无杂质。

    杂质会造成快速磨损並縮短部件使用寿命。


  1. 按与拆卸相反的顺序安装燃油注油泵 (4)。

Caterpillar Information System:

CG137-12 Generator Set Maintenance Interval Schedule
XQ400 Power Module Fluid Recommendations
CG137-08 and CG137-12 Engines Refill Capacities
XQ400 Power Module Before Starting Engine
CG137-12 Generator Set Sensors and Electrical Components
XQ400 Power Module Electronic Modular Control Panel 4 (EMCP 4) - EMCP 4.4
XQ400 Power Module Alarms and Shutoffs
CG137-08 and CG137-12 Engines Plate Locations and Film Locations
C7 and C9 Industrial Engines Engine Cranks but Does Not Start
C15 and C18 Engines for Caterpillar Built Machines ECM Does Not Communicate with Other Modules
C7 and C9 Industrial Engines Cylinder Is Noisy
C7 and C9 Industrial Engines Oil Consumption Is Excessive
C7 and C9 Industrial Engines Engine Has Mechanical Noise (Knock)
C7 and C9 Industrial Engines Air Shutoff - Test
C4.4 Engines Valve Position - Test
C4.4 and C7.1 Engines Water in Fuel - Test
C4.4 Engines for Caterpillar Built Machines Temperature Sensor (Catalyst Inlet) - Remove and Install
C3.4B Engines NOx Sensor - Test
C4.4 Engines for Caterpillar Built Machines Ammonia Sensor - Remove and Install - Ammonia Sensor if Equipped
C4.4 Engines for Caterpillar Built Machines Temperature Sensor (Exhaust) - Remove and Install - Selective Catalytic Reduction (SCR) Temperature Sensor
Cat® Reman Injectors with Invalid Injector Trim Files {1290} Cat® Reman Injectors with Invalid Injector Trim Files {1290}
2014/09/26 A New Special Instruction Is Now Available for Bypassing EGR Relay in EMCP2 Controls on Certain Generator Sets {1908, 4490, 4493}
C175-16 PETROLEUM ENGINES Fuel Transfer Pump - Remove and Install
C3.4B Engines Power Take-Off - Test
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.