G3306B Petroleum Generator Set Engines Caterpillar


Electronic Control System Components

Usage:

G3306B NR4



Illustration 1g03700489

Fuel Actuator




Illustration 2g01914692

Location of the fuel actuator (right side top engine view)

(1) Fuel actuator

Fuel actuator (1) is electronically controlled and electrically actuated. The fuel actuator and the ECM communicate via the CAN data link.

Throttle Actuator




Illustration 3g01917653

Location of the throttle actuator (left side top engine view)

(2) Throttle actuator

Throttle actuator (2) is electronically controlled and electrically actuated. The ECM issues commands to the actuator via the CAN data link.

Engine Sensors

Sensors provide information to the ECM. The information is used for monitoring engine operation. The information enables the ECM to control the engine as efficiently as possible over a wide range of operating conditions.

The sensors provide signals to the ECM that are used in the determination of the states of engine alarms and of engine shutdowns. These conditions may be in response to abnormal operation or to a command that is initiated by the operator.




Illustration 4g03430004

Locations of the engine components (left side engine view)

(3) Engine coolant temperature sensor

(4) Intake manifold air temperature sensor

(5) Intake manifold pressure sensor

(6) Engine oil temperature sensor




Illustration 5g03430165

Locations of the engine components (right side engine view)

(7) Ignition transformers

(8) Electronic Control Module (ECM)

(9) Service tool connector that is mounted on the engine

(10) Engine speed/timing sensor

(11) Alternator

(12) Oxygen sensor for the inlet of the catalyst

(13) Display panel

(14) Power converter

(15) Starting motor

(16) Oil pressure sensor

(17) Connector for the sensors at the catalytic converter

(18) Connector for the interconnect harness

(19) Panel for the circuit breakers

Sensors for the Catalytic Converter/Muffler




Illustration 6g01938513

Locations of the sensors that are for the catalytic converter/muffler

(20) Temperature sensor for the inlet of the catalytic converter/muffler

(21) Temperature sensor for the outlet of the catalytic converter/muffler

(22) Oxygen sensor for the outlet of the catalyst

Circuit Breaker Panel




Illustration 7g01938594

Locations of the circuit breakers that are at the circuit breaker panel

(23) Circuit breaker for the ECM (15 amp)

(24) Circuit breaker for the auxiliary circuit (20 amp)

(25) Circuit breaker for the starting system (40 amp)

(26) Circuit breaker for the alternator (40 amp)

Caterpillar Information System:

XQC1200 and XQC1600 Power Modules Pistons and Connecting Rods - Install
455-7245 Major Overhaul Foundational Kit for C18 Marine Engines{1000} 455-7245 Major Overhaul Foundational Kit for C18 Marine Engines{1000}
XQC1200 and XQC1600 Power Modules Pistons and Connecting Rods - Remove
C280 Marine Engines Coolant Pressure Is Low
C280 Marine Engines DEF Tank Sensor - Test
C8.7 Marine Engine Starting Aid (Air Inlet Heater) - Inspect/Clean/Replace
C175-20 Locomotive Engine Solenoid Valve - Test - Aftertreatment
C8.7 Marine Engine Cold Weather Starting
C8.7 Marine Engine Aftercooler Condensate Drain Valve - Inspect/Clean
455-7246 Major Overhaul Foundational Kit for C18 Marine Engines{1000} 455-7246 Major Overhaul Foundational Kit for C18 Marine Engines{1000}
330F MHPU Mobile Hydraulic Power Unit Machine System Control Valve
2014/07/18 Plate on Long Blocks on C6.6 and C4.4 Engines {1201}
XQC1200 and XQC1600 Power Modules Crankshaft Main Bearings - Remove and Install
455-1186 Major Overhaul Foundational Kit for C18 Marine Engines{1000} 455-1186 Major Overhaul Foundational Kit for C18 Marine Engines{1000}
2014/07/18 Improved Exhaust Risers Are Available for 3208 Naturally Aspirated Marine Engines {1380}
2015/02/20 New Front and Rear Crankshaft Seals Are Now Used on Certain 3500 and G3500 Engines {1160, 1161}
455-1187 Major Overhaul Foundational Kit for C18 Marine Engines{1000} 455-1187 Major Overhaul Foundational Kit for C18 Marine Engines{1000}
Well Service Pumps Pump (Fluid End) Suction Manifold Seals - Replace
558 Forest Machine Fuel System Secondary Filter - Replace
Well Service Pumps Pump (Fluid End) Discharge Flanges and Seals - Inspect
Well Service Pumps Pump (Fluid End) Suction Pulsation Dampener - Check
455-1185 Major Overhaul Foundational Kit for C18 Marine Engines{1000} 455-1185 Major Overhaul Foundational Kit for C18 Marine Engines{1000}
C8.7 Marine Engine Engine Mounts - Inspect
Well Service Pumps Pump (Fluid End) Mounting Bolts - Check
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.