Connectors for the Electronic Control Module (ECM)
 | |
| Illustration 1 | g01890453 |
ADEM 4 ECM (J1/P1 ECM connector) 64-Pin connector (J2/P2 ECM connector) 64-Pin connector | |
Harness Connector for the Fuel Actuator
 | |
| Illustration 2 | g01941553 |
Harness Connector at the Throttle Actuator
 | |
| Illustration 3 | g01941779 |
Power Converter
 | |
| Illustration 4 | g01910374 |
Harness Connectors
Connector for the Interconnect Harness
 | |
| Illustration 5 | g01941836 |
Connector for the Sensors at the Catalytic Converter
 | |
| Illustration 6 | g02038838 |
Sensor Connectors
Analog Sensor Connector (Active)
 | |
| Illustration 7 | g01240891 |
Analog Sensor Connector (Passive)
 | |
| Illustration 8 | g01436505 |
Connectors for Oxygen Sensors
| | |
| Illustration 9 | g01240891 |
Typical connector for the oxygen sensor and sensor buffer | |
Connectors for the Termination Resistor
 | |
| Illustration 10 | g01707176 |
Typical connector for the termination resistor | |
Display Panel
Terminal Strip in the Display Panel
 | |
| Illustration 11 | g02731375 |
Terminal locations from left to right for the terminal strip that is in the display panel (1) CAN shield (2) CAN data link− (3) CAN data link+ (4) Amber warning lamp (5) Red stop lamp (6) Engine running lamp (7) Speed potentiometer (8) Idle/rated speed switch (9) Engine stop signal (10) Engine running signal (11) Digital return (12) Unused (13) Crank terminate (14) Emergency stop (15) Keyswitch (16) −Battery (17) +Battery (18 and 19) Two resistors for the speed potentiometer | |
Connector for the Messenger Display
 | |
| Illustration 12 | g01941894 |
Aftertreatment Identification Module and Timing Selection Switch
 | |
| Illustration 13 | g03685572 |
(20) Aftertreatment Identification Module (21) Timing Selection Switch Connector | |
 | |
| Illustration 14 | g03700464 |
Typical example of the customer supplied timing selection switch male connector (Terminal 1) Timing Selection Switch Signal (Terminal 2) Analog Return | |