C13 Industrial Engine Caterpillar

Removal Procedure

Show/hide table

Illustration 1	g03663427

1. Remove cable straps (1). Disconnect harness assembly (2). Loosen clamp (3), clamp (4), and remove tube (6), and hose (5).
   Show/hide table

   Illustration 2	g03663470

2. Disconnect harness assembly (8). Remove bolts (10). Remove bolts (9) and venturi tube (7).
   Show/hide table

   Illustration 3	g03663479

3. Remove bolts (11) and pressure sensor (NRS differential) (13) from venturi tube (7). Remove pressure sensor (NRS absolute) (12) from venturi tube (7).

Installation Procedure

1. Install venturi tube (8) in the reverse order of removal.

   Note: Do not reuse clamp (3), clamp (4), and hose (5).

   1. Tighten pressure sensor (12) to a torque of 10 ± 2 N·m (89 ± 18 lb in).

   2. Tighten bolts (11) to a torque of 20 ± 2 N·m (177 ± 18 lb in).

   3. Replace hoses (6) and (9).

   4. Replace clamps (7) and (10 ).

   5. Replace clamp (4).

   6. Use Tooling (A) to lubricate the inner part of clamp (4)

   7. Tighten clamp (4) to a torque of 8.5 ± 2 N·m (75 ± 18 lb in).