Fuel Manifold (Rail)
Refer to Operation and Maintenance Manual, "General Hazard Information and High Pressure Fuel Lines" before adjustments and repairs are performed.
Show/hide table
| NOTICE |
|---|
Refer to Systems Operation, Testing and Adjusting, "Cleanliness of Fuel System Components" for detailed information on the standards of cleanliness that must be observed during ALL work on the fuel system. |
Show/hide table
 | |
| Illustration 1 | g03653734 |
Typical example | |
(1) Tighten the bolts to the following torque. ... 55 N·m (41 lb ft)
(2) Tighten the fuel pressure relief valve to the following torque. ... 30 N·m (22 lb ft)
Note: The fuel pressure relief valve (2) should be tightened an additional 24 degrees.
(3) Tighten the bolts to the following torque. ... 10 N·m (89 lb in)
(4) Tighten the nuts to the following torque. ... 44 N·m (32 lb ft)
Caterpillar Information System:
C4.4 Marine Generator Set Control Panel - Marine Classification Society (MCS) Control Panel (If Equipped)
390F MHPU Mobile Hydraulic Power Unit Machine System Specifications Fuel Tank
G3306B Generator Sets Overhaul (Top End)
390F Excavator Machine Systems Swing Motor - Remove and Install - Rear
390F Excavator Machine Systems Swing Motor - Remove and Install - Front
390F MHPU Mobile Hydraulic Power Unit Machine System Specifications Front Lines
390F Excavator Machine Systems Swing Motor - Assemble
793F and 797F Off-Highway Trucks Power Train Electronic Control System Transmission Clutch Slips
390F Excavator Machine Systems Swing Motor - Disassemble
C4.4 Marine Generator Set Fuel Filter Base
390F Excavator Machine System Front Lines
390F MHPU Mobile Hydraulic Power Unit Machine System Specifications Fuel Tank and Mounting
2014/05/16 New Air Inlet Valves and Valve Seats Are Used On Certain C27and C32 Industrial Engines {1100, 1101}
2014/04/04 A New Gas Shutoff Valve (GSOV) Is Used for Certain G3508 and G3512 Petroleum Engines {1274, 5479}
390F Excavator Machine Systems Swing Drive - Remove and Install
DE Series Generator Set With Cat C4.4 Engine Product Description
C9.3 Marine Auxiliary Engines Maintenance Interval Schedule - Marine Auxiliary Engine
390F Excavator Machine Systems Swing Gear and Bearing - Remove
390F Excavator Machine Systems Swing Gear and Bearing - Install
G3306B Generator Sets Carburetor Air/Fuel Ratio - Check/Adjust
C13, C15, and C18 Tier 4 Final Engines Turbocharger
C13, C15, and C18 Tier 4 Final Engines Turbocharger
C13, C15, and C18 Tier 4 Final Engines Air Inlet Elbow
C13, C15, and C18 Tier 4 Final Engines Diesel Exhaust Fluid Tank