Initial Filling of the Dosing Cabinet Tank with Diesel Exhaust Fluid (DEF){108K, 108T} Caterpillar


Initial Filling of the Dosing Cabinet Tank with Diesel Exhaust Fluid (DEF){108K, 108T}

Usage:

3516C SCJ
Engine:
3516C (S/N: SKC1-UP; SCJ1-UP; SCK1-UP; SFK1-UP)
C175-16 (S/N: WYC1-UP)

Introduction

This Special Instruction provides the procedure in order for the initial filling of the dosing cabinet tank with DEF.

On the initial filling of the dosing cabinet tank with DEF fluid, the aftertreatment ECM will log the following low tank level event codes: 1761-1, 1761-17, and 1761-18

The engine ECM will log the following code: 4792-31

Initial Filling




Illustration 1g03390629

The 1761-1, level 3 (most severe) low tank level event code will prevent the engine from starting. Upon initial filling of the dosing cabinet tank, once the DEF fluid level is above 55 percent full, the logged event codes can be cleared. These must be cleared to allow the engine to start. Refer to Illustration 1.

Caterpillar Information System:

2013/06/06 Utilizing CLAAS OMM Information for Certain Caterpillar Industrial Engines {1000}
Well Stimulation Pumps Pump (Fluid End) Suction Pulsation Dampener - Check
2013/06/06 New Fuel Pressure Sensors Are Available to Replace the ARD Pilot and Main Pressure Sensors on Certain Engines {1274, 1439, 1702}
374F Excavator Cab Door
3512E Tier 4 Final Engines for Land Electric Drilling Oil Filter Differential Pressure Problem
Well Stimulation Pumps Pump (Fluid End) Plunger Lube System - Check
Well Stimulation Pumps Pump (Fluid End) Plunger Lube Oil Level - Check
Well Stimulation Pumps Safety Messages
Well Service Pumps Operation
Well Stimulation Pumps Before Operation
C27 and C32 Generator Sets Product Installation
Well Stimulation Pumps Crushing Prevention and Cutting Prevention
Well Stimulation Pumps Pump (Power End) Lube Oil Filter - Replace - If Equipped
WS273 XD, WS305 XD, WSF273 XD, WSF305 XD, WSP273 and WSP305 Well Stimulation Pumps Manifold (Suction) - Remove and Install
C27 Petroleum Engine Product Description
Well Service Pumps Pump (Power End) Lube Oil Pressure - Check
Well Stimulation Pumps Pump (Power End) Lube Oil Level - Check
Well Stimulation Pumps Pump (Power End) Lube System - Check
Well Stimulation Pumps Pump (Power End) Lube Suction Strainer - Clean
Well Stimulation Pumps Pump (Power End) Lube Oil - Change
C27 Industrial Engine and C27 Locomotive Engine Model View Illustrations
374F Excavator Hydraulic System Check Valve (Load)
Procedure For Tightening of SAE Plugs on Certain Flywheel UPS Products{1156, 4480} Procedure For Tightening of SAE Plugs on Certain Flywheel UPS Products{1156, 4480}
C32 Marine Engine Engine Oil Level Gauge - Calibrate
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.