Auxiliary Water Pump - Remove and Install
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 拆下螺栓 (1)、螺栓 (3)、螺栓 (7) 和弯头 (2)。
- 拆下螺栓 (4)、螺栓 (5) 和适配器 (6)。
Show/hide table
图 2 g03368068 - 拆下螺栓 (8) 并断开适配器 (9)。
- 拆下螺栓 (10),然后拆下节温器控制阀总成 (11)。
Show/hide table
图 3 g03368168 - 应辅助水泵 (13)以及附件驱动轴和附件驱动齿轮视为一个整体拆卸。 辅助水泵 (13)、附件驱动轴以及附件驱动齿轮的重量约为
48 kg (106 lb) 。 用一个合适的举升设备将辅助水泵 (8)、附件驱动轴和附件驱动齿轮拆下。 拆下将辅助水泵 (13) 固定到前驱动壳体的螺栓 (12)。 将辅助水泵 (13)、附件驱动轴和附件驱动齿轮作为一个整体拆卸。
Show/hide table
图 1 | g03362303 |
- 按与拆卸相反的顺序安装辅助水泵 (13)。
Caterpillar Information System:
G3512H and G3516H Generator Set Engines Water Pump - Remove and Install
G3512H and G3516H Generator Set Engines Water Temperature Regulators - Remove and Install
303.5E2 CR, 304E2 CR, 305E2 CR and 305.5E2 CR Mini Hydraulic Excavators Machine System Operational Checks
XQP150 Rental Generator Set Fuel System Primary Filter (Water Separator) Element - Replace
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies Universal Network Interface PWA (Flywheel Cabinet)
Marine Engine Control Panel I Wiring Diagrams
C3.3B Tier 4 Final Engines for Caterpillar Built Machines Gear Group (Front)
C3.3B Tier 4 Final Engines for Caterpillar Built Machines Connecting Rod
C4.4 Generator Sets Control Panel
C7.1 Marine Engine Relief Valve (Fuel) - Remove and Install - Low Pressure System Relief Valve
C7.1 Marine Engine Relief Valve (Fuel) - Remove and Install - Fuel Rail Pressure Relief Valve
C4.4 Generator Sets Single Unit Operation
2013/04/04 The Starter Solenoid is Improved on Certain Machines {1453}
C7.1 Marine Engine Cylinder Head - Remove
C3.3B Tier 4 Final Engines for Caterpillar Built Machines Flywheel
C7.1 Marine Engine Cylinder Head - Install
C4.4 and C7.1 Engines CAN Data Link - Test
C7.1 Marine Engine Generator - Remove and Install
2013/05/28 New Flywheel Housing Assemblies and Gasket Are Used on Certain Marine and Petroleum 3500 Engines {1157, 7555}
C3.3B Tier 4 Final Engines for Caterpillar Built Machines Engine Oil Pan
C3.3B Tier 4 Final Engines for Caterpillar Built Machines Crankcase Breather
C15 and C18 Engines Engine Oil and Filter - Change
C3.3B Tier 4 Final Engines for Caterpillar Built Machines Exhaust Manifold
2013/04/04 An Additional Spacer Is Now Used in the Crankshaft Pulley Group of Certain C7 and C9 Marine Engines {1205}