Water Temperature Regulators - Remove and Install
Show/hide table
| 所需工具 | |||
| 工具 | 零件号 | 零件描述 | 数量 |
| A | 439-3938 | 连杆支架 | 2 |
Show/hide table
| 注意 |
|---|
|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
Show/hide table
| 注意 |
|---|
|
在检查、保养、测试、调整及维修产品时，请小心确保盛接油液。 在打开任何舱室或拆卸任何含有油液的部件前，请准备好盛接液体用的适当容器。 |
- 排空冷却液。 有关正确的排放和加注步骤，请参考操作和保养手册, "冷却液 (NGEC) - 更换"。
Show/hide table
图 1 g03360879 - 拆下螺栓 (1)、断开弯头 (2)，然后拆下螺栓 (3)。
- 将调节器壳体组件 (6) 固定到位，然后拆下螺栓 (5) 和支架 (4)。 调节器壳体组件 (6) 的重量约为
30 kg (66 lb) 。 - 需要两名人员拆下调节器壳体组件 (6)。
Show/hide table
图 2 g03361241 - 从调节器壳体组件 (6) 上拆下水温调节器 (7)。
Show/hide table
图 3 g03361522 Show/hide table
图 4 g03361586 - 拆下螺栓 (8) 和螺栓 (10)。
- 拆下螺栓 (11)。
- 拆下调节器壳体 (9) 。
- 按与拆卸相反的顺序安装水温调节器 (7)。
Caterpillar Information System:
303.5E2 CR, 304E2 CR, 305E2 CR and 305.5E2 CR Mini Hydraulic Excavators Machine System Operational Checks
XQP150 Rental Generator Set Fuel System Primary Filter (Water Separator) Element - Replace
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies Universal Network Interface PWA (Flywheel Cabinet)
Marine Engine Control Panel I Wiring Diagrams
C3.3B Tier 4 Final Engines for Caterpillar Built Machines Gear Group (Front)
C3.3B Tier 4 Final Engines for Caterpillar Built Machines Connecting Rod
C4.4 Generator Sets Control Panel
C7.1 Marine Engine Relief Valve (Fuel) - Remove and Install - Low Pressure System Relief Valve
C7.1 Marine Engine Relief Valve (Fuel) - Remove and Install - Fuel Rail Pressure Relief Valve
C4.4 Generator Sets Single Unit Operation
126-6918 Lifting Bracket Assembly{0599, 0629, 0632, 0701, 1100} 126-6918 Lifting Bracket Assembly{0599, 0629, 0632, 0701, 1100}
UPS1000Z, UPS1200Z, UPS500G and UPS600G Uninterruptible Power Supplies UPS View Commands and Hot Keys
G3512H and G3516H Generator Set Engines Water Pump - Remove and Install
G3512H and G3516H Generator Set Engines Auxiliary Water Pump - Remove and Install
2013/04/04 The Starter Solenoid is Improved on Certain Machines {1453}
C7.1 Marine Engine Cylinder Head - Remove
C3.3B Tier 4 Final Engines for Caterpillar Built Machines Flywheel
C7.1 Marine Engine Cylinder Head - Install
C4.4 and C7.1 Engines CAN Data Link - Test
C7.1 Marine Engine Generator - Remove and Install
2013/05/28 New Flywheel Housing Assemblies and Gasket Are Used on Certain Marine and Petroleum 3500 Engines {1157, 7555}
C3.3B Tier 4 Final Engines for Caterpillar Built Machines Engine Oil Pan
C3.3B Tier 4 Final Engines for Caterpillar Built Machines Crankcase Breather
C15 and C18 Engines Engine Oil and Filter - Change