General Information
The System Operation manual contains instructions for installing and using the Marine Engine Control Panel I (MECP I). Refer to Illustration 1. The three important sections covered in this manual are listed below:
- Introduction
- Installation Instructions
- User Guide
The MECP I is an engine mounted panel that provides key switch, start, and stop functions in the engine room. The MECP I can monitor engine communications. The communications are to show vessel information and alert the user of any diagnostic warnings.
Show/hide table
 | |
| Illustration 1 | g03358317 |
Marine Engine Control Panel I(MECP I) (1) Display (2) Diagnostic message indicators (3) Engine controls (4) Wiring connectors (5) Display controls | |
Caterpillar Information System:
349E Excavator Machine System Specifications Hydraulic Filter and Lines
C4.4 and C7.1 Engines Valve Lash Is Excessive
C4.4 and C7.1 Engines Power Is Intermittently Low or Power Cutout Is Intermittent
349F and 352F Excavators Machine System Specifications Auxiliary Pump Drive and Mounting
C4.4 Generator Sets Voltage Regulators
C4.4 Generator Sets Plate Locations and Film Locations
C280-16 Engine Gauges and Indicators
UPS 750 Uninterruptible Power Supply System Bypass Operation
UPS 750 Uninterruptible Power Supply System Startup
UPS 750 Uninterruptible Power Supply Site Preparation
UPS 750 Uninterruptible Power Supply General Information (Installation)
2013/03/15 DC Circuit Breaker Test Procedure on Certain Uninterruptible Power Supply {1420, 4480}
C3.4B Industrial Engine Diesel Particulate Filter - Wall Flow Diesel Particulate Filter (DPF)
Marine Engine Control Panel I Dimensions
2013/10/16 Improved Water Manifold Gaskets Are Used for Certain 3500 Machine Engines {1124, 1380, 7555}
2013/10/17 Improved Water Manifold Gaskets Are Used on Certain 3500 Engines {1124, 1380, 7555}
374F Excavator Hydraulic System Electronic Control (Main Pump System)
C3.4B Industrial Engine Flexible Exhaust Pipe
C7.1 Marine Engine Fuel Temperature Sensor - Remove and Install
C7.1 Marine Engine Engine Oil Temperature Sensor - Remove and Install
G3500H 50Hz Generator Sets Starting the Engine
C7.1 Marine Engine Pressure Sensor (Engine Coolant) - Remove and Install - Auxiliary Water Pump Pressure Sensor
2013/07/22 New Exhaust Manifold Seals Are Available for Certain 3500 Engines {1059, 7555}
C3.4B Industrial Engine Diesel Particulate Filter - Through Flow Diesel Particulate Filter (DPF)