Pilot Lines
Show/hide table
| |
| Illustration 1 | g03356529 |
Show/hide table
| Specification for 330-2513 Pilot Lines Gp | |||
| Item | Qty | Part | Specification Description |
| - | - | - | Sharp corners at each strap cutting edge shall not be allowed. |
| 1 | 1 | 148-8378 Elbow As | In case of aluminum manifold, torque to |
Show/hide table
| |
| Illustration 2 | g03356533 |
Show/hide table
| Item | Qty | Part | Specification Description |
| 2 | 1 | 148-8336 Connector As | Torque to |
| 3 | 1 | 148-8353 Elbow As | Torque to |
| 4 | 1 | 168-1968 Tee As | Torque to |
| 5 | 4 | 7X-2538 Bolt | Torque to |
Caterpillar Information System:
3516B Engine for the MT4400D Off-Highway Truck Cover Group (Rear Housing)
374F Excavator Machine System Oil Filter (Hydraulic)
C3.3B Tier 4 Final Engines for Caterpillar Built Machines Fuel Injection Lines
C7.1 Marine Engine Fuel Injection Lines - Remove and Install - Double Wall Fuel Injection Lines
C7.1 Marine Engine Fuel Injection Lines - Remove and Install - Non M.C.S. Fuel Injection Lines
C18 Marine Engines Diagnostic Trouble Codes
C7.1 Marine Engine Air Starting Motor - Remove and Install
C3.3B Tier 4 Final Engines for Caterpillar Built Machines Boost Pressure Sensor
G3500H 50Hz Generator Sets Additional Messages
2013/03/29 Improved VisionLinkTM Store for Minimizing Delay in Appearance of VisionLink Store - Modules is Now Available for All Caterpillar Products {7606}
2013/03/29 Device Transfers Are Now Supported In VisionLinkTM Store {7606}
2013/03/13 A New Injector Hydraulic Pump Group Is Available For Certain C9 Marine Engines {1714}
966M Tier 4 and 972M Tier 4 Wheel Loaders Power Train Torque Converter from Transmission, Output Transfer Gears - Separate
2013/03/22 Use Nickel Anti-Seize When Installing Thermocouples on Engines {7498, 7555}
349F and 352F Excavators Machine System Specifications Hoist Solenoid Valve
G3512H and G3516H Generator Set Engines Electronic Control Module (Engine) - Remove and Install
966M Tier 4 and 972M Tier 4 Wheel Loaders Power Train Torque Converter to Transmission, Output Transfer Gears - Connect
C7.1 Marine Engine Aftercooler - Remove and Install - Keel-Cooled
C7.1 Marine Engine Heat Exchanger - Remove and Install - Sea Water Cooled Engine
C9.3 Engines for Caterpillar Built Machines Relay (ARD Nozzle Heater) - Remove and Install
2013/06/13 A New Compressor Bypass Actuator is Used on Certain G3500B Engines {1803, 5510}
777F, 777G, and 785D OEM Off-Highway Truck/Tractors Water Delivery System Pressure Sensor (Motor Inlet)
C7.1 Marine Engine Heat Exchanger - Disassemble - Sea Water Cooled Engine
C9.3 Engines for Caterpillar Built Machines Nozzle Heater Harness - Remove and Install