Crankshaft Front Seal - Remove and Install
Removal Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 367-3534     | Oil Seal Removal & installer Tool     | 1     |
Start By:
- Remove the crankshaft pulley.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Position Tooling (A) onto crankshaft front seal (2) .
Show/hide table
Illustration 1 | g02445196 |
- Turn Tooling (A) in a counterclockwise direction and remove crankshaft front seal (2) from front cover (1) .
Installation Procedure
- Correctly position a new crankshaft front seal (2) in Position (X) onto front cover (1) .
Show/hide table
Illustration 2 | g03344801 |
- Position Tooling (A) onto crankshaft front seal (2) .
- Use Tooling (A) in order to turn crankshaft front seal (2) in clockwise direction.
- If a force greater than 50 N·m (37 lb ft) is required to install the crankshaft front seal (2) , remove crankshaft front seal (2) . Inspect the crankshaft front seal and the front cover for faults or damage.
- If necessary repeat Step 1 through Step 4 in order to install crankshaft front seal (2) .
End By: Install the crankshaft pulley.
Caterpillar Information System:
C7.1 Marine Engine Vibration Damper and Pulley - Remove and Install
C7.1 Marine Engine Flywheel Housing - Remove and Install
C7.1 Marine Engine Crankshaft Rear Seal - Remove and Install
2013/06/11 A New Prelube Solenoid Valve is Used in Certain G3500 Petroleum Engines {1462, 5479}
C7.1 Marine Engine Flywheel - Remove and Install
C7.1 Marine Engine Auxiliary Water Pump - Assemble
C7.1 Marine Engine Auxiliary Water Pump - Disassemble
C7.1 Marine Engine Auxiliary Water Pump - Remove and Install
C175-16 Locomotive Engine Exhaust Temperature Is Low
C175-16 Locomotive Engine Exhaust Temperature Is High
C175-16 Locomotive Engine Exhaust Has Excessive White Smoke
C175-16 Locomotive Engine Engine Does Not Crank
C7.1 Marine Engine Front Cover - Remove and Install
C175-16 Locomotive Engine Fuel Pressure Is High - Fuel Supply System
C175-16 Locomotive Engine Fuel Pressure Is Low - Fuel Supply System
C175-16 Locomotive Engine Oil Contains Coolant
C7.1 Marine Engine Gear Group (Front) - Remove and Install
C7.1 Marine Engine Idler Gear - Remove and Install
C7.1 Marine Engine Housing (Front) - Remove and Install
C32 Auxiliary Engine Fuel System Secondary Filter - Replace
C7.1 Marine Engine Valve Mechanism Cover - Remove and Install
2013/02/06 A New Turbocharger Coolant Line Is Used on Certain 3512C Locomotive Engines {1380}
C7.1 Marine Engine Rocker Shaft and Push Rod - Remove and Install
C7.1 Marine Engine Engine Oil Pan - Remove and Install