C4.4 Industrial Engine Caterpillar

Fuel System Primary Filter/Water Separator - Drain

Usage:

C4.4 448

Show/hide table

Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately.

Show/hide table

NOTICE

Ensure that the engine is stopped before any servicing or repair is performed.

Show/hide table

NOTICE

The water separator can be under suction during normal engine operation. Ensure that the drain valve is tightened securely to help prevent air from entering the fuel system.

Place a suitable container under the water separator in order to catch any fluid that might spill. Clean up any spilled fluid.
Ensure that the outer body of the filter assembly is clean and free from dirt.
Show/hide table

Illustration 1 g02148370

Typical example
Install a suitable tube onto drain (3). Open the drain valve (2). Rotate the drain valve counterclockwise. Two full turns are required. Loosen vent screw (1).
Allow the fluid to drain into the container.
Tighten the drain valve clockwise by hand pressure only. Remove the tube and remove the container.
Tighten the vent screw securely.