DEF Pressure Is High
Show/hide table
故障诊断代码     | |||
---|---|---|---|
J1939 代码     | CDL 代码     | 代码说明     | 注释     |
4334-16     | E930(2)     | 后处理 1 柴油机排气处理液剂量仪绝对压力:高 - 中等严重程度(2)     | DCU 检测到 DEF 泵压力高于可接受的范围。 记录该代码。     |
遵循故障排除步骤来确定故障根源。     |
Show/hide table
图 1 | g03755376 |
(1) DEF 集管处的回流管接头 (2) DEF 泵回流管路连接 |
按所列步骤顺序完成以上步骤。
Show/hide table
故障诊断与排除测试步骤     | 数值     | 结果     |
---|---|---|
1. 检查回流管有无阻塞 A. 把钥匙开关转到断开位置。 继续之前等待 2 分钟。 B. 将回流管从 DEF 集管和 DEF 泵上拆下。 C. 检查回流管有无阻塞。 如有必要,用水/低压空气冲洗管路。 阻塞物可能是冰、DEF 沉积物或碎屑。     |
阻塞     |
结果:发现阻塞物。 修理:冲洗或更换管路。 继续测试步骤 4。 结果:未发现阻塞物。 转至测试步骤 2。     |
2. 更换回流接头 A. 更换 DEF 泵上的回流接头。 有关正确步骤,请参阅拆解与组装手册。     |
更换回流接头     |
结果:更换接头。 转至测试步骤 3。     |
3. 检查 DEF 泵有无阻塞 A. 将回流管重新安装到 DEF 泵上。 将管路的另一端放入桶或烧杯内以收集 DEF。 B. 把钥匙开关转到接通位置。 不要起动发动机。 C. 连接到 Cat® ET 中的"柴油机排气处理液控制器 #1 ECM"。 D. 执行 "DEF 喷射系统验证测试"。 有关详细信息,请参考故障诊断与排除, "Cat ET 维修功能"。     |
存在 DEF     |
结果:DEF 没有从 DEF 回流管流入容器内。 修理:更换 DEF 泵,然后重新安装所有 DEF 管路。 有关正确步骤,请参阅拆解与组装手册。 继续测试步骤 4。 结果:DEF 从回流管流入容器内。 修理:将回流管重新安装到 DEF 集管上。 继续测试步骤 4。     |
4. 执行"后处理系统功能测试 " A. 起动发动机。 B. 连接到 Cat ET 中的"发动机 #1 后处理控制器"。 C. 执行"后处理系统功能测试"。     |
诊断代码     |
结果:测试成功。 使机组返回工作。 结果:测试不成功。 具有附加代码。 修理:对附加代码进行故障排除。 关于正确的步骤,参考故障排除。 确认故障已排除。     |
Caterpillar Information System:
C13, C15, and C18 Tier 4 Final Engines Electric Starting Motor
C4.4 Industrial Engine Fuel System Secondary Filter - Replace
C4.4 Industrial Engine Fuel System Primary Filter/Water Separator - Drain
C4.4 Industrial Engine Fuel System Primary Filter (Water Separator) Element - Replace
C6.6 Industrial Engine Engine Crankcase Breather Element - Replace
C9.3 Industrial Engine Turbocharger
C7.1 Industrial Engine Maintenance Interval Schedule
G3500 Engines Cylinder Head
C32 Marine Engines Unit Injector Sleeve - Install
C32 Marine Engines Unit Injector Sleeve - Remove
793F Off-Highway Truck Engine Supplement Turbocharger - Remove and Install - High Altitude
C7.1 Industrial Engine Fuel Filter (In-Line) - Replace
C9 On-highway Engines ARD Combustion - Test
C7 and C9 On-Highway Engines Diesel Particulate Filter Collects Excessive Soot
C9 On-highway Engines ARD Failed to Ignite
C9 On-highway Engines ARD Temperature Is Low
C280-16 Petroleum Engine Flywheel
C280-16 Petroleum Engine Flywheel
C7.1 Industrial Engine Engine Oil Level - Check
Handling and Unpacking Instructions for the Uninterruptible Power Supply{4480} Handling and Unpacking Instructions for the Uninterruptible Power Supply{4480}
C7.1 Industrial Engine Engine - Clean
C7.1 Industrial Engine Electrical System
2012/07/31 A New Charging Alternator Group Is Available for Certain C15 and C18 Industrial Engines {1405}
2012/07/19 A New Procedure Is Used to Secure the Fuel Injection Lines Group on Certain 3412, 3412C, and 3412D Commercial Engines {1252, 1254}