C7.1-XQ230 Rental Generator Set Caterpillar


Setup

Usage:

XQ230 CK2

------ WARNING! ------

Discharge air is hot and could cause property damage and/or personal injury.


Note: Do not operate the unit below any overhang.



Illustration 1g06389062
Typical flow of the exhaust


Illustration 2g06389089
Top view of the package and the typical clearance around the package

The unit should have adequate clearance on all sides to allow proper air flow. Allow approximately 2 m (6.6 ft) of clearance on all sides.

  • Place the unit in a stable position.

  • Ensure that you use wheel chocks that are suitable for the trailer.

  • Unfasten the tow vehicle before you operate the unit.


NOTICE

Ensure that the enclosure doors are closed and locked during generator set operation. Access to the generator set is prohibited during operation of the generator set. Access to the emergency stop push button cannot be obstructed or restricted. The emergency stop push button must be easily seen and the emergency stop push button must be readily accessible. The door latch cannot be lockable. The door latch cannot contain a provision for making the door latch lockable.


------ WARNING! ------

Failure to close doors when the unit is operating can result in doors opening and closing at a high rate of speed. Contact with the doors may cause personal injury or death.




Illustration 3g06389090
Typical chocking of the wheels and door latches

Caterpillar Information System:

Inspection and Salvage of Front Wheel Spindles for Off-Highway Trucks {4201, 4205} Inspection and Salvage of Front Wheel Spindles for Off-Highway Trucks {4201, 4205}
C15 and C18 Tier 4 Final Engines DEF Dosing Control System
2012/05/07 An Improved Guide Spring and Valve Lifter Assembly Are Available in Certain C9 ACERT Engines {1209}
C3.3B and C3.8 Engines for Caterpillar Built Machines Fuel Rail Pressure Is Low
C3.3B and C3.8 Engines for Caterpillar Built Machines Engine Vibration Is Excessive
C3.3B and C3.8 Engines for Caterpillar Built Machines Engine Top Speed Is Not Obtained
C3.3B and C3.8 Engines for Caterpillar Built Machines Engine Stalls at Low RPM
C3.3B and C3.8 Engines for Caterpillar Built Machines Engine Overspeeds
C3.3B and C3.8 Engines for Caterpillar Built Machines Engine Misfires, Runs Rough or Is Unstable
C3.3B and C3.8 Engines for Caterpillar Built Machines Engine Has Mechanical Noise (Knock)
C3.3B and C3.8 Engines for Caterpillar Built Machines Cylinder Is Noisy
C3.3B and C3.8 Engines for Caterpillar Built Machines Coolant Temperature Is High
C175-16 Generator Set Refill Capacities
2012/05/07 A Procedure to Check Ash Build-up Within the Diesel Particulate Filter (DPF) Is Now Available {108F}
C32 Marine Engines Coolant Level Sensor - Remove and Install
C3.3B and C3.8 Engines for Caterpillar Built Machines Oil Pressure Is Low
2012/05/14 New Flash Files Are Available for Certain Engines {1901, 1920}
C9.3 Tier 4 Final Engines Diagnostic Trouble Codes
C9.3 Tier 4 Final Engines Event Codes
2012/06/25 Obsolete Merlin Gerin CK and CM Frame Circuit Breaker Replacements Are Now Available {1420, 4461}
G3516C and G3516E Gas Engines Exhaust Manifold
C9.3 Tier 4 Final Engines Engine Cranks but Does Not Start
325 VM and VH Variable Gauge Undercarriage Final Drive - Disassemble
C32 Marine Engines Engine Oil Pressure Sensor - Remove and Install
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.