C13, C15, and C18 Tier 4 Final Engines Caterpillar


Camshaft

Usage:

826K 232


图 1g02983376
发动机右视图

表 1
331-0964 凸轮轴总成的技术规格 
项目  数量  零件  技术规格说明 
119-0036 平头螺钉  拧紧至扭矩为 13 ± 3 N·m (115 ± 27 lb in)。 
348-2587 凸轮轴  在安装凸轮轴之前,用清洁的发动机机油润滑凸轮轴轴承。
用按 50/50 比例混合的 8T-2998 润滑剂和清洁的发动机机油润滑凸轮轴凸轮。 
凸轮轴轴颈的直径为 84.85 ± 0.02 mm (3.341 ± 0.001 in)。 


图 2g02983378

表 2
项目  数量  零件  技术规格说明 
使用以下步骤确定实际凸轮轴凸轮升程 (B):
1. 测量凸轮轴凸轮高度 (C)。
2. 测量基圆 (D)。
3. 从凸轮轴凸轮高度 (C) 中减去基圆 (D)。 二者之差就是实际凸轮轴凸角升程。 
规定的凸轮轴凸轮升程: 
进气凸轮为 9.431 mm (0.3713 in)
排气凸轮为 8.515 mm (0.3352 in)
喷油器凸轮为 10.908 mm (0.4294 in)

Caterpillar Information System:

C15 Generator Set Engine Exhaust Manifold
3500B Engines Air Shutoff - Remove and Install
CX48-P2300 Petroleum Transmission Transmission Speed Sensor (Torque Converter Output)
Installation of Cat® Terrain for Landfill Compactors, Motor Graders, Wheel Dozers, and Wheel Loaders {7605} Installation of Cat® Terrain for Landfill Compactors, Motor Graders, Wheel Dozers, and Wheel Loaders {7605}
3500B Engines Air Shutoff - Assemble
3500B Engines Air Shutoff - Disassemble
3500 Generator Sets Air Inlet Filter - Inspect/Clean/Test
C3.3B and C3.8 Engines for Caterpillar Built Machines Fuel Rail Pressure Is High
UPS 120, UPS 150, UPS 250 and UPS 300 Uninterruptible Power Supplies Additional Features
3512C and 3516C Marine Auxiliary Engines Switch Circuits - Test
CX48-P2300 Petroleum Transmission Transmission Oil Filter (Transmission)
G3516C and G3516E Gas Engines Gas Engine Ignition
2012/04/24 New Software Is Used on Certain C27 Industrial Engines Equipped with Rear Mounted Turbochargers {1901, 1920}
C175-16 Locomotive Engine Crankcase Pressure Is High
C175-16 Locomotive Engine ECM Does Not Communicate with Other Modules
3512C and 3516C Marine Auxiliary Engines Speed Control - Test
3512C and 3516C Marine Auxiliary Engines Direct Fuel Control Mode - Test
3512C and 3516C Marine Auxiliary Engines Starting - Test
C4.4 Marine Generator Set Generator Lead Connections
C4.4 Marine Generator Set Refill Capacities
C13, C15, and C18 Tier 4 Final Engines Water Pump
C11 and C13 Engines Water Pump
C15 and C18 Engines for Caterpillar Built Machines Water Pump
3500C Marine Engines Engine Oil Lines
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.