Coolant Level - Check
Show/hide table
为了接近这个保养位置可能需要登上机器。 有关安全的详细资料,请参考本操作和保养手册, "上、下设备"专题。 |
配备有目测表的散热器
Show/hide table
图 1 | g02722611 |
散热器目测表的典型示例。 (1) 加注口盖 (2) 目测表 |
如果发动机配备了目测液位计,观察目测液位计中冷却液的位置。 在正常工作温度下,正确的冷却液液位是在目测液位计的上半部。 如果冷却液液位过低,添加正确的冷却剂混合液。
未配备有目测表的散热器
Show/hide table
加压的系统: 热的冷却液能造成严重的烫伤。 在发动机停机,等待冷却系统部件冷却下来后再打开冷却系统加注口盖。 缓慢松开冷却系统加注口盖,以释放掉所有压力。 |
发动机停机并冷却后检查冷却液液位。 发动机已关闭且加注口盖冷却到可徒手触摸后,再检查冷却液液位。
慢慢拆下冷却系统加注口盖,以释放掉压力。 将冷却液液位保持在距加注管底部以下 13 mm (0.5 in) 范围内。
添加冷却液
注: 有关要使用的正确冷却液混合液,请参见本操作和保养手册, "油液建议"(保养部分)。 有关应使用的冷却液量,请参阅本操作和保养手册, "加注容量"(保养部分)。
- 关闭发动机。 让发动机冷却。
- 慢慢拆下冷却系统加注口盖,以释放掉压力。 将正确的冷却剂混合液注入冷却液加注管。
- 清洗冷却系统加注口盖。 检查冷却系统加注口盖密封垫的状况。 如果冷却系统加注口盖密封垫损坏,请用新件更换旧的冷却系统加注口盖。 安装冷却系统加注口盖。
Show/hide table
图 2 | g00103639 |
密封垫 |
- 起动发动机。 检查冷却系统是否泄漏。
Caterpillar Information System:
C32 Marine Generator Set Sensors and Electrical Components
CG137-08 and CG137-12 Industrial Engines Carburetor (Low Pressure Gas) - Adjust
CG137-08 and CG137-12 Generator Sets Exhaust Temperature Sensor
C3.4B Engines For Caterpillar Built Machines Temperature Sensor (NOx Reduction System)
CG137-08 and CG137-12 Generator Sets Exhaust Temperature Sensor
C3.4B Engines for Caterpillar Built Machines Exhaust Cooler (NRS) - Test
Coolant Leaking from the Joint for the Tube to the Water Temperature Regulator Housing on Certain 3508B Locomotive Engines{1355, 1380, 1393} Coolant Leaking from the Joint for the Tube to the Water Temperature Regulator Housing on Certain 3508B Locomotive Engines{1355, 1380, 1393}
C32 Marine Generator Set General Maintenance Information - Service Hours and Fuel Consumption
C32 Marine Generator Set Engine Air Cleaner Service Indicator - Inspect
2011/09/29 Fuel Injection Pump Mounting Flange on Certain 3056E Engines {1251, 1290}
C3.4B Engines For Caterpillar Built Machines Inlet Manifold Temperature and Pressure Sensor - If equipped
C3.4B Engines For Caterpillar Built Machines Temperature Sensor (DOC Inlet)
XQ570 Rental Generator Set Parallel Operation
C13-XQ350 Rental Generator Set Battery Disconnect Switch
C15 Generator Set Electronic Modular Control Panel 4 (EMCP 4) - EMCP 4.3/4.4
C15 Generator Set Plate Locations and Film Locations
C13-XQ350 Rental Generator Set Generator Operation
XQ570 Rental Generator Set Product Lifting
Cat® Detect Object Detection System MID 134 - CID 0247 - FMI 09
Cat® Detect Object Detection System MID 134 - CID 0248 - FMI 09
Cat® Detect Object Detection System MID 134 - CID 2348 - FMI 09
Cat® Detect Object Detection System MID 134 - CID 3317 - FMI 09
Cat® Detect Object Detection System MID 134 - CID 3317 - FMI 12
Cat® Detect Object Detection System MID 134 - CID 3318 - FMI 09