Electronic Control Unit - Flash Program
Show/hide table
| Required Tools | |
| WinFlash Software | |
Perform the following procedures to flash program an ECU. The ECU is flashed in order to upgrade software. The ECU is flashed in order to load software into an ECU. Flash programming of an ECU must also be done if the ECU has been replaced. The Caterpillar Electronic Technician (ET) contains the program WinFlash. WinFlash is used to load software into the ECU. The following procedure is used in order to flash software into an ECU.
- Connect the 139-4166 Data Link Cable between the 7x-1700 Communication Adapter and the diagnostic connector of the machine.
- Use WinFlash to load the new software.
Note: The ECU will indicate that the ECU is "BLANK" if the ECU is blank or an unsuccessful "FLASH" was performed.
Caterpillar Information System:
CX28 Transmission For Combat and Tactical Vehicles Transmission ; Transfer Case Electronic Control System Wiring Harness (Open Circuit) - Test
CX28 Transmission For Combat and Tactical Vehicles Transmission ; Transfer Case Electronic Control System Electronic Control Unit - Replace
CX28 Transmission For Combat and Tactical Vehicles Transmission ; Transfer Case Electronic Control System Transmission - Calibrate
CX28 Transmission For Combat and Tactical Vehicles Transmission ; Transfer Case Electronic Control System Speed Sensor - Replace
C13, C15, and C18 Tier 4 Final Engines Temperature Sensor (NOx Reduction System)
C32 Generator Set Product Lifting
G3520E Generator Set Engines Engine Does Not Crank
G3520E Generator Set Engines Generator Output Power Sensor - Set
C15 Petroleum Engines Exhaust Has Excessive White Smoke
Rework Procedure for the Connector with Filter Addition for All Excavators{3206, 5264, 5467, 5479} Rework Procedure for the Connector with Filter Addition for All Excavators{3206, 5264, 5467, 5479}
CX28 Transmission For Combat and Tactical Vehicles Transmission ; Transfer Case Electronic Control System Diagnostic Capabilities
CX28 Transmission For Combat and Tactical Vehicles Transmission ; Transfer Case Electronic Control System Emerging Symptom Information
CX28 Transmission For Combat and Tactical Vehicles Transmission ; Transfer Case Electronic Control System Wiring Harness (Short Circuit) - Test
C13 Engines for Caterpillar Built Machines Exhaust Gas Valve (NRS)
CX28 Transmission For Combat and Tactical Vehicles Transmission ; Transfer Case Electronic Control System Electronic Control Unit - Configure
Selecting Correct Part Numbers For Sensors and Adapter Harnesses for Certain Machines and Engines{1408, 1439} Selecting Correct Part Numbers For Sensors and Adapter Harnesses for Certain Machines and Engines{1408, 1439}
CX28 Transmission For Combat and Tactical Vehicles Transmission ; Transfer Case Electronic Control System Electrical Connector - Inspect
CX28 Transmission For Combat and Tactical Vehicles Transmission ; Transfer Case Electronic Control System Transmission, SPN 4046 - FMI 3
CX28 Transmission For Combat and Tactical Vehicles Transmission ; Transfer Case Electronic Control System Transmission, SPN 4045 - FMI 5
CX28 Transmission For Combat and Tactical Vehicles Transmission ; Transfer Case Electronic Control System Transmission, SPN 746 - FMI 3
C13, C15, and C18 Tier 4 Interim Engines Variable Valve Actuator - Test
CX28 Transmission For Combat and Tactical Vehicles Transmission ; Transfer Case Electronic Control System Transmission, SPN 441 - FMI 3
C15 and C18 Engines Engine Oil and Filter - Change
G3516 Power Module Product Description