Emissions Certification Film
Show/hide table
| |
| Illustration 1 | g02281173 |
|
Typical example | |
The emission label, refer to illustration 1 will be installed on the front cover of the engine.
Show/hide table
| |
| Illustration 2 | g02052934 |
|
Typical example | |
Caterpillar will supply the fuel label with every engine. Refer to illustration 2. The equipment manufacturer must install the label to the equipment. The label must be attached to the equipment near the inlet of the fuel tank. This action will comply with the EPA regulations. The equipment manufacturer may install another fuel label . If another fuel label is used, the equipment manufacturer must send a drawing or a photo of the label to Caterpillar through the Cat dealer. This action will ensure compliance of the label.
Caterpillar Information System:
12M Motor Grader Engine Starting
D6T Track-Type Tractor Engine Air Precleaner - Clean
C9.3 Tier 4 Final Engines Turbocharger
C6.6 Industrial Engine Exhaust Back Pressure Valve - Remove and Install
C1.5 and C2.2 Industrial Engines Engine Electronics
2010/12/06 A New Throttle Actuator Is Used for Some G3500 and G3500B Engines {1265, 1716}
3306B Generator Set Product Lifting
C1.5 and C2.2 Industrial Engines Model View Illustrations - Engines and Aftertreatment
C1.5 and C2.2 Industrial Engines Safety Messages
349E, 349F and 352F Excavators and 349E MHPU Mobile Hydraulic Power Unit Tool Control System Solenoid Valve (Proportional Reducing) - Calibrate - Pilot Pressure Limit
C27 and C32 Engines for Caterpillar Built Machines Pressure Sensor (Cooled Exhaust Gas) - Remove and Install - NRS Differential Pressure
C27 and C32 Engines for Caterpillar Built Machines Pressure Sensor (Cooled Exhaust Gas) - Remove and Install - NRS Intake
12M, 140M and 160M Motor Graders Hydraulic and Steering System Solenoid Valve (Blade Cushion)
C1.5 and C2.2 Industrial Engines Sensors and Electrical Components - Engine and Aftertreatment
G3512E and G3520E Generator Set Engines Electronic Control Module (ECM)
3516C Locomotive Engines Control Cabinet - Disassemble
3516C Locomotive Engines Control Cabinet - Assemble
C6.6 Industrial Engine Flexible Exhaust Pipe - Remove and Install
C6.6 Industrial Engine Exhaust Elbow - Remove and Install
C1.5 and C2.2 Industrial Engines Refill Capacities and Recommendations
C27 and C32 Industrial Engines Rear Power Take-Off (RPTO) - Remove
EMCP4.3/4.4 Pulse Width Modulated Output Programming
EMCP4.1/EMCP4.2 General Information
EMCP4.1/EMCP4.2 Service Tools