Cylinder Head - Inspect
Show/hide table
图 1 | g02260053 |
缸盖平面度(典型示例) (A) 边到边 (B) 端到端 (C) 对角线 |
- 从一侧至相对一侧 (A) 测量缸盖。
- 从一端至相对一端 (B) 测量缸盖。
- 从一角至相对一角 (C) 测量缸盖。
请参考技术规格, "缸盖"以了解平面度要求。
如果发生下述任何一种情况,可以重修缸盖底面。
- 缸盖底面平面度不符合技术规格。
- 缸盖底面因穴蚀、腐蚀或磨损而引起损坏。
注: 缸盖机加工后,缸盖厚度不得小于
注: 在重修缸盖表面后,气门座至火焰面的尺寸必须正确。 请参考技术规格, "缸盖"以了解正确的气门座尺寸。
Caterpillar Information System:
C7.1 (Mech) Industrial Engine Connecting Rod Bearings - Inspect
C7.1 Engines for Caterpillar Built Machines Valve Guide - Inspect
C7.1 Engines for Caterpillar Built Machines Valve Depth - Inspect
C7.1 (Mech) Industrial Engine Engine Valve Lash - Inspect/Adjust
C7.1 (Mech) Industrial Engine Compression - Test
C7.1 (Mech) Industrial Engine Turbocharger - Inspect
C7.1 (Mech) Industrial Engine General Information
C15 and C18 Tier 4 Final Engines Cleanliness of Fuel System Components
C7.1 (Mech) Industrial Engine Air Inlet and Exhaust System
C7.1 (Mech) Industrial Engine Basic Engine
C27 and C32 Industrial Engines Fuel Filter Base - Remove and Install
2010/09/17 A New Torque Is Used for the Check Valve Group on Certain Marine Engines {1261, 1262, 1274, 5067}
312E, 312F, 313F, 316E, 316F, 318E, 318F, 320E, 320F, 323E, 323F, 324E, 325F, 326F, 329E, 329F, 330F, 335F, 336E, 336F, 340F, 349E, 349F, 352F, 374F and 390F Excavators and 336E MHPU and 349E MHPU Mobile Hydraulic Power Units Air Conditioning and Hea Refrigerant Receiver-Dryer
C7.1 (Mech) Industrial Engine V-Belt - Test
3512C HD Locomotive Engine Safety Messages
C7.1 (Mech) Industrial Engine Main Bearings - Inspect
C15 and C18 Petroleum Generator Sets Fluid Recommendations
C3.3 and C4.4 Generator Sets Product Installation
C7.1 Engines for Caterpillar Built Machines Connecting Rod - Inspect
C15 Petroleum Generator Set Engines Piston and Rings
C13 Tier 4 Final Engines Fuel Pressure Regulator
3516B HD Generator Set Engine Oil and Filter - Change
320E and 323E Excavators Swing Bearing - Lubricate
349F and 352F Excavators System Pressure Release