Turbocharger Inlet Pressure Sensor - Remove and Install
拆卸步骤
Show/hide table
| 注意 |
|---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 断开线束组件并拆下涡轮增压器进口压力传感器 (1) 。
Show/hide table
 | |
| 图 1 | g02256654 |
- 将 O 形密封圈从涡轮增压器进口压力传感器上拆下。
安装步骤
Show/hide table
| 所需工具 | |||
|---|---|---|---|
| 工具 | 零件号 | 零件描述 | 数量 |
| A | 1U-6396 | O 形圈组装固定胶 | - |
Show/hide table
| 注意 |
|---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 为涡轮增压器进口压力传感器 (1) 安装一个新的 O 形密封圈。 将工具 (A) 涂抹在 O 形密封圈上。
Show/hide table
| | |
| 图 2 | g02256654 |
- 安装涡轮增压器进口压力传感器 (1) 并拧紧至扭矩为 10 ± 2 N·m (89 ± 18 lb in)。
- 连接线束组件。
Caterpillar Information System:
3500 Engines Engine Oil Pressure Sensor - Remove and Install
2010/12/13 An Improved Plate Gasket Is Used Between the Spacer Plate and the Cylinder Block on Certain C27 and C32 Engines {1201, 7555}
3500 Engines Air Shutoff - Remove and Install
Servicing Procedure for the Auxiliary Water Pump Seal on Certain C-12 and C12 Marine Engines{1371} Servicing Procedure for the Auxiliary Water Pump Seal on Certain C-12 and C12 Marine Engines{1371}
2010/10/18 Contamination Control Guidelines for Marine Engine Rebuilds, Repair, and/or Overhauls {1000}
C27 and C32 Engines for Caterpillar Built Machines Crankcase Pressure Sensor - Remove and Install
312E, 312F, 313F, 316E, 316F, 318E, 318F, 320E, 320F, 323E, 323F, 324E, 325F, 326F, 329E, 329F, 330F, 335F, 336E, 336F, 340F, 349E, 349F, 352F, 374F and 390F Excavators and 336E MHPU and 349E MHPU Mobile Hydraulic Power Units Air Conditioning and Hea Refrigerant Condenser
312E, 312F, 313F, 316E, 316F, 318E, 318F, 320E, 320F, 323E, 323F, 324E, 325F, 326F, 329E, 329F, 330F, 335F, 336E, 336F, 340F, 349E, 349F, 352F, 374F and 390F Excavators and 336E MHPU and 349E MHPU Mobile Hydraulic Power Units Air Conditioning and Hea Refrigerant Compressor
C27 and C32 Engines for Caterpillar Built Machines Inlet Air Temperature Sensor - Remove and Install - Right Side and Left Side
3500 Engines Aftercooler - Remove and Install
2010/09/14 New O-Rings Are Used with the Plugs for the Fuel Passages in 3500 Engines {1100, 1101, 1252, 1254}
C27 and C32 Generator Set Engines Vibration Damper and Pulley
3500 Engines Turbocharger Outlet Pressure Sensor - Remove and Install
3500 Engines Coolant Temperature Sensor - Remove and Install
3500 Engines Aftercooler Coolant Temperature Sensor - Remove and Install
3500 Engines Atmospheric Pressure Sensor - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Solenoid Valve (Exhaust Balance) - Remove and Install
2010/10/08 Discontinued, Genuine Cat Parts Now Available From Vintage Parts , Inc. At Your Cat Dealers {1000, 7000}
3500 Engines Fuel Pressure Sensor - Remove and Install
3512C HD Locomotive Engine Model View Illustrations
2010/09/17 A New Torque Is Used for the Check Valve Group on Certain Marine Engines {1261, 1262, 1274, 5067}
C27 and C32 Industrial Engines Fuel Filter Base - Remove and Install
C7.1 (Mech) Industrial Engine Basic Engine
C7.1 (Mech) Industrial Engine Air Inlet and Exhaust System