Engine Oil Pan
Show/hide table
 | |
| Illustration 1 | g02169945 |
- Tighten the bolts 1 through 40 which secure the engine oil pan, in a numerical sequence to a torque of 47 ± 9 N·m (35 ± 7 lb ft). Refer to Illustration 1 for the proper torque sequence.
- Recheck the torque of bolts 1 through 40.
Show/hide table
 | |
| Illustration 2 | g02170077 |
(41) Oil pan gasket | |
(A) Apply 4C-9612 Silicone Sealant on both sides of the ball and socket joints of the oil pan gasket.
Caterpillar Information System:
2010/06/17 Concerns for Engines with Seawater Cooling in Oil Polluted Water {1000, 1394}
C13, C15, and C18 Tier 4 Interim Engines Exhaust Balance Valve - Test
C175 Generator Sets Belt Tensioner - Check
C27 Petroleum Generator Set Engines Oil Temperature Is High
C27 Petroleum Generator Set Engines Pressure Sensor - Calibrate
C175 Generator Sets Belts - Inspect/Replace
C27 and C32 Engines for Caterpillar Built Machines Aftercooler - Test - If Equipped
C27 Petroleum Generator Set Engines Intake Manifold Air Temperature Is High
C7.1 Industrial Engine and Generator Set ARD Failed to Ignite
C175-16 Marine Propulsion Engines Alternator Mounting
C15 and C18 Tier 4 Final Engines Engine Oil Pressure - Test
C27 Petroleum Generator Set Engines Fuel Pressure Is Low
C27 Generator Set Engines Component Location
CX31 On-Highway Transmission Power Train Retarder Hydraulic Control Valve - Remove and Install
C27 and C32 Generator Set Engines Fuel Lines - Remove and Install
PM3516 Power Modules Parking
Procedure for Correctly Lifting Certain C32 Generator Set Enclosures{7002} Procedure for Correctly Lifting Certain C32 Generator Set Enclosures{7002}
XQ125 Generator Set Trailer - Inspect
3500 Engines Air Lines
3500 Engines Air Lines
C4.4 Industrial Engine Engine - Clean
3500 Engines Air Shutoff
3500 Engines Water Lines - Aftercooler
C175-16 Marine Propulsion Engines Turbocharger Oil Lines