Speed Sensor (Engine) - Adjust
Show/hide table
Illustration 1 | g00289497 |
Speed Sensor (1) Speed sensor (2) Locknut (A) Air gap |
Note: The engine speed sensor is commonly referred to as a magnetic pickup sensor.
This adjustment procedure is for the engine speed sensor.
- Remove the speed sensor (1) from the flywheel housing. Remove all debris from the tip of the speed sensor. Align a ring gear tooth directly in the center of the threaded sensor opening.
- By hand, screw the speed sensor (1) into the hole until the end of the sensor contacts the gear tooth.
- Turn the sensor (1) in the counterclockwise direction through 270 degrees (three-fourths turn).
- Tighten locknut (2) to
25 ± 5 N·m (18 ± 4 lb ft) .Note: Do not allow speed sensor (1) to turn as locknut (2) is tightened.
Caterpillar Information System:
EMCP4.1/EMCP4.2 Engine Setpoint Verification - Test
EMCP4.1/EMCP4.2 Electronic Control Module (Generator Set) - Replace
349F and 352F Excavators Engine Oil Level - Check
Transmission Reuse and Salvage Manual Contents {0374, 3030} Transmission Reuse and Salvage Manual Contents {0374, 3030}
EMCP4.1/EMCP4.2 Electrical Connector - Inspect
EMCP4.1/EMCP4.2 Wiring Harness (Open Circuit) - Test
EMCP4.1/EMCP4.2 Wiring Harness (Short Circuit) - Test
EMCP4.1/EMCP4.2 Diagnostic Capabilities
EMCP4.1/EMCP4.2 Diagnostic Trouble Code List
EMCP4.1/EMCP4.2 Engine Cooldown Warning
EMCP4.1/EMCP4.2 Engine Overcrank Warning
EMCP4.1/EMCP4.2 Engine Overspeed Warning
EMCP4.1/EMCP4.2 External Potential Transformer Connections
C175-16 Marine Engines Speed Sensor - Clean/Inspect
EMCP4.1/EMCP4.2 Engine Speed Timing Calibration - Setup
349F and 352F Excavators Fumes Disposal Filter Element - Replace - If Equipped
EMCP4.1/EMCP4.2 System Operation
EMCP4.1/EMCP4.2 Event Viewing
EMCP4.1/EMCP4.2 Voltage and Frequency Adjustment
EMCP4.1/EMCP4.2 Thermocouple Module - EMCP 4.2 Only
EMCP4.1/EMCP4.2 Resistive Temperature Device Module
C7.1 Industrial Engine and Generator Set Engine Temperature Sensor Open or Short Circuit - Test
C175-16 Petroleum Generator Set Engines Air Shutoff - Test
2010/08/10 Procedure for Cleaning the Fuel Valve Gp on G3500C and G3500E Engines {1254, 1714, 5086}