Diagnostic Capabilities
Caterpillar Electronic Technician (Cat ET)
Show/hide table
Illustration 1 | g02283173 |
Caterpillar Electronic Technician (Cat ET) is a software program that is used to access data. The service technician can use the Cat ET in order to perform the maintenance. Some of the options that are available with the Cat ET are listed below:
- Diagnosis of problems
- Viewing diagnostic trouble codes
- Viewing active event codes and logged event codes
- View the status of parameters.
- Clear active diagnostic trouble codes and clear logged diagnostic trouble codes
- Perform calibration of machine systems.
- Program the ECU (Flash). Use "WINflash" to program the ECU. Refer to Testing and Adjusting, "Electronic Control Module (Generator Set) - Flash Program".
- Print reports.
Refer to Troubleshooting, "Diagnostic Trouble Code List". Diagnostic information is accessed with the following drop-down menus:
- Active diagnostic trouble codes
- Logged diagnostic trouble codes
Status groups are lists of machine parameters. The statuses of the parameters are shown in real time. To enable status groups, select the status tool icon. Select an existing group on the left, or create a temporary group. Add the desired parameters to view. Illustration 2 shows a temporary group.
Show/hide table
Illustration 2 | g02286655 |
Caterpillar Information System:
EMCP4.1/EMCP4.2 Diagnostic Trouble Code List
EMCP4.1/EMCP4.2 Engine Cooldown Warning
EMCP4.1/EMCP4.2 Engine Overcrank Warning
EMCP4.1/EMCP4.2 Engine Overspeed Warning
EMCP4.1/EMCP4.2 Engine Speed Warning
EMCP4.1/EMCP4.2 Engine Underspeed Warning
EMCP4.1/EMCP4.2 Generator Control Not in Automatic Warning
EMCP4.1/EMCP4.2 Generator Output Sensing Circuit Fault
EMCP4.1/EMCP4.2 Generator Overcurrent Warning
EMCP4.1/EMCP4.2 Generator Overfrequency Warning
EMCP4.1/EMCP4.2 Generator Overvoltage Warning
EMCP4.1/EMCP4.2 Generator Reverse Power Warning
EMCP4.1/EMCP4.2 Wiring Harness (Short Circuit) - Test
EMCP4.1/EMCP4.2 Wiring Harness (Open Circuit) - Test
EMCP4.1/EMCP4.2 Electrical Connector - Inspect
Transmission Reuse and Salvage Manual Contents {0374, 3030} Transmission Reuse and Salvage Manual Contents {0374, 3030}
349F and 352F Excavators Engine Oil Level - Check
EMCP4.1/EMCP4.2 Electronic Control Module (Generator Set) - Replace
EMCP4.1/EMCP4.2 Engine Setpoint Verification - Test
EMCP4.1/EMCP4.2 Speed Sensor (Engine) - Adjust
EMCP4.1/EMCP4.2 External Potential Transformer Connections
C175-16 Marine Engines Speed Sensor - Clean/Inspect
EMCP4.1/EMCP4.2 Engine Speed Timing Calibration - Setup
349F and 352F Excavators Fumes Disposal Filter Element - Replace - If Equipped