Exhaust Cooler (NRS) - Remove and Install
- Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct draining and filling procedures.
Show/hide table
Illustration 1 g02168278 - Remove clamps (1). Remove nuts (3) and elbow assembly (2).
- Remove elbow assemblies (4) and (6).
- Remove bolts (5).
Show/hide table
Illustration 2 g02169114 - Remove nuts (7). Remove exhaust gas cooler (8).
Show/hide table
Illustration 3 g02070034 Note: Discard bellows (9) after use.
- Loosen clamp assembly (10) and separate bellows (9) from elbow (2). Discard bellows (9).
- Install exhaust gas cooler (8) in reverse order of removal.
- Tighten nuts (3) to a torque of
70 ± 5 N·m (52 ± 4 lb ft) . - Tighten clamps (1) and (10) to a torque of
7.5 ± 1 N·m (66 ± 9 lb in) .Show/hide tableIllustration 4 g02070093 - Ensure that the end of bellows (9) with the taper (A-A) is facing the exhaust manifold.
- Tighten nuts (3) to a torque of
Caterpillar Information System:
C15 and C18 Engines for Caterpillar Built Machines Engine Oil Pan - Remove and Install - C15 Engine
C13 Engine for Caterpillar Built Machines Inlet and Exhaust Valve Seat Inserts - Remove and Install
C13 Engine for Caterpillar Built Machines Inlet and Exhaust Valve Guides - Remove and Install
C13 Engine for Caterpillar Built Machines Inlet and Exhaust Valves - Remove and Install
793F and 797F Off-Highway Trucks Braking System Brakes Drag
C12 Marine Engines Heat Exchanger - Inspect/Clean
793F CMD Off-Highway Truck (Command for Hauling) Power Train Electronic Control System Backup Alarm Does Not Function
C15 and C18 Engines for Caterpillar Built Machines Cylinder Head - Remove and Install
C9.3 Tier 4 Interim Engines Engine Cranks but Does Not Start
C6.6 Industrial Engine Lifter Group
C13 Engine for Caterpillar Built Machines Inlet and Exhaust Valve Springs - Remove and Install
C6.6 Industrial Engine Fuel Filter Base - Single Secondary Fuel Filter Base
C6.6 Industrial Engine Cylinder Head Valves
C6.6 Industrial Engine Main Bearing Journal
C4.4 Industrial Engine Piston and Rings
C7.1 Industrial Engine and Generator Set Sensors and Electrical Connectors
MP-15, MP-20, MP-30 and MP-40 Multi Processors Hydraulic Rotator
C13, C15, and C18 Tier 4 Interim Engines Oil Contains Coolant
C15 and C18 Industrial Engines Atmospheric Pressure Sensor - Remove and Install
C12 Marine Engines Engine Valve Lash - Inspect/Adjust
C15 and C18 Engines for Caterpillar Built Machines Crankcase Pressure Sensor - Remove and Install
C12 Marine Engines Fuel System Secondary Filter - Replace
C13, C15, and C18 Tier 4 Interim Engines Engine Does Not Crank
C15 and C18 Engines for Caterpillar Built Machines Engine Oil Pressure Sensor - Remove and Install