Flywheel
Show/hide table
Illustration 1 | g00584712 |
Typical example |
(1) Flywheel ring gear
- Heat the flywheel ring gear to the following temperature. ...
250 °C (480 °F)
Note: Do not use an oxyacetylene torch to heat the flywheel ring gear.
(2) Flywheel
(3) Bolt
- Tighten the flywheel bolts to the following torque. ...
140 N·m (103 lb ft)
Caterpillar Information System:
C6.6 Industrial Engine Flywheel Housing
C4.4 Industrial Engine Gear Group (Front)
C7.1 Industrial Engine Water Pump
C7.1 Engines for Caterpillar Built Machines Piston Cooling Jet
C6.6 Industrial Engine Connecting Rod
C6.6 Industrial Engine Connecting Rod Bearing Journal
C6.6 Industrial Engine Crankshaft Seals
C7.1 Engines for Caterpillar Built Machines Cylinder Block
C6.6 Industrial Engine Water Temperature Regulator and Housing
C6.6 Industrial Engine Engine Oil Pump
C6.6 Industrial Engine Engine Oil Filter Base
C6.6 Industrial Engine Exhaust Manifold
C4.4 Industrial Engine Engine Lifting Bracket
2009/04/06 Improved Procedure for Verifying the Operation of the Battery Disconnect System. {1411}
Problems with Rough Idle on Certain C15 Truck Engines{1901, 1920} Problems with Rough Idle on Certain C15 Truck Engines{1901, 1920}
C6.6 Industrial Engine Alternator
C15 and C18 Engines for Caterpillar Built Machines Coolant Temperature Sensor
C6.6 Industrial Engine Engine Oil Pressure Sensor
C6.6 Industrial Engine Inlet Manifold Temperature Sensor
G3500B Engines Fuel Lines
C15 and C18 Industrial Engines Water Pump - Remove and Install
2009/04/01 Cleaning a Plugged Diesel Particulate Filter (DPF) {108F}
C18 Generator Set Emissions Certification Film
2009/03/23 New Water Lines Groups Are Used for Venting of the Separate Circuit Aftercooler (SCAC) {1353, 1380}