Piston Cooling Jet
Show/hide table
图 1 | g01352576 |
(1) 已安装的活塞冷却喷嘴 |
气门必须能够自由运动。 螺栓的扭矩 ...
Show/hide table
图 2 | g01352578 |
(2) 活塞冷却喷嘴
(3) 杆 (4) 缸体 |
按照以下步骤检查活塞冷却喷嘴的对准度。
- 将杆 (3) 插入活塞冷却喷嘴 (2) 的端部。 杆 (3) 的直径为
1.70 mm (0.067 in) 。 杆 (3) 必须高出缸体的顶部。 - 尺寸 (A) 为
58.5 mm (2.30315 in) ,尺寸 (B) 为13.5 mm (0.53150 in) 。 尺寸 (A) 及尺寸 (B) 与气缸内径 (4) 相切。 - 杆 (3) 的位置必须在尺寸 (C) 范围内。 尺寸 (C) 为
10 mm (0.39370 in) 。
注: 检查对准度时要确保杆 (3) 不会损坏活塞冷却喷嘴。 活塞冷却喷嘴不能调整。 如果活塞冷却喷嘴不能对准,则必须更换。
Caterpillar Information System:
C6.6 Industrial Engine Connecting Rod
C6.6 Industrial Engine Connecting Rod Bearing Journal
C6.6 Industrial Engine Crankshaft Seals
C7.1 Engines for Caterpillar Built Machines Cylinder Block
C6.6 Industrial Engine Water Temperature Regulator and Housing
C6.6 Industrial Engine Engine Oil Pump
C6.6 Industrial Engine Engine Oil Filter Base
C6.6 Industrial Engine Exhaust Manifold
C6.6 Industrial Engine Camshaft
C6.6 Industrial Engine Rocker Shaft
C6.6 Industrial Engine Cylinder Head
C7.1 Industrial Engine Engine Design
C7.1 Industrial Engine Water Pump
C4.4 Industrial Engine Gear Group (Front)
C6.6 Industrial Engine Flywheel Housing
C4.4 Industrial Engine Flywheel
C4.4 Industrial Engine Engine Lifting Bracket
2009/04/06 Improved Procedure for Verifying the Operation of the Battery Disconnect System. {1411}
Problems with Rough Idle on Certain C15 Truck Engines{1901, 1920} Problems with Rough Idle on Certain C15 Truck Engines{1901, 1920}
C6.6 Industrial Engine Alternator
C15 and C18 Engines for Caterpillar Built Machines Coolant Temperature Sensor
C6.6 Industrial Engine Engine Oil Pressure Sensor
C6.6 Industrial Engine Inlet Manifold Temperature Sensor
G3500B Engines Fuel Lines