Stub Shaft (Front)
Show/hide table
 | |
| 图 1 | g01744573 |
典型实例 | |
注: 短轴 (3) 上的对准标记必须与接头 (1) 上的标记对准。
注: 在拧紧螺栓前，在螺栓螺纹上涂敷一层二硫化钼润滑脂。
(2) 螺栓扭矩 ... 1150 ± 60 N·m (848 ± 44 lb ft)
Caterpillar Information System:
G3500B Engines Speed/Timing - Test
TH48-E70 Petroleum Transmission and TH48-E70-C27I, TH48-E70-C32I and TH48-E70-C32P Petroleum Power Train Packages Speed Sensor (Transmission) - Torque Converter Output
2008/11/17 The 6V-4022 Fuel Injector Tester Is not Available {1251, 1254, 1290, 1713}
TH48-E70 Petroleum Transmission and TH48-E70-C27I, TH48-E70-C32I and TH48-E70-C32P Petroleum Power Train Packages Speed Sensor (Transmission) - Engine Output
2008/11/17 The 6V-4022 Fuel Injector Tester Is not Available {1251, 1254, 1290, 1713}
G3520C and G3520E Generator Set Engines Vibration Damper - Remove
G3520C and G3520E Generator Set Engines Vibration Damper - Assemble
2008/11/17 Do Not Use the 6V-4022 Fuel Injector Tester to Measure Unit Injector Fuel Flow Rate {1251, 1254, 1290, 1713}
G3520C and G3520E Generator Set Engines Vibration Damper - Disassemble
2008/12/01 Water Temperature Regulator {1355, 1380}
793F and 797F Off-Highway Trucks Chassis Electronic Control System System Schematic
G3500B Engines Camshaft
3500 Engines with EUI Option Turbocharger
3500 Engines with EUI Option Turbocharger
2008/11/17 Do Not Use the 6V-4022 Fuel Injector Tester to Measure Unit Injector Fuel Flow Rate {1251, 1254, 1290, 1713}
3306C Engines for Caterpillar Built Machines Turbocharger
2008/11/01 Do Not Use the 6V-4022 Fuel Injector Tester to Measure Unit Injector Fuel Flow Rate {1251, 1254, 1290, 1713}
2008/11/17 Calibration Fluid for Fuel Nozzle Test Equipment Is Available {0782, 1251, 1254, 1290, 1713}
2008/11/17 Do Not Use the 6V-4022 Fuel Injector Tester to Measure Unit Injector Fuel Flow Rate {1251, 1254, 1290, 1713}
2008/11/01 Do Not Use the 6V-4022 Fuel Injector Tester to Measure Unit Injector Fuel Flow Rate {0782, 1251, 1254, 1290, 1713}
C15 and C18 Generator Set Engines Flywheel - Install
Roll Over Protective Structure and Falling Object Protective Structure Identification Film Retention{7000, 7405, 7557} Roll Over Protective Structure and Falling Object Protective Structure Identification Film Retention{7000, 7405, 7557}
2008/11/17 The Pop (Injector) Tester Is not Available for Fuel Injectors {0782, 1251, 1254, 1290, 1713}
2008/11/17 The Pop (Injector) Tester Is not Available for Fuel Injectors {0782, 1251, 1254, 1290, 1713}