Closed Crankcase Ventilation (CCV) Fumes Disposal Filter - Replace
发动机可能看起来像下图中的其中一种。
Show/hide table
图 1 | g01637464 |
Show/hide table
图 2 | g01637466 |
(1) 曲轴箱呼吸器 (2) 烟雾处理滤清器座和滤清器 (3) 空气滤清器 |
封闭式曲轴箱通风系统(CCV) 需要更换烟雾处理滤清器。 CCV 的使用周期将会受下列各项的影响:
- 发动机的负载
- 烟灰浓度
- 发动机状况
CCV 配备一个保养指示器。 如果烟雾处理滤清器在正常保养周期之前堵塞,滤清器阻力升高,将导致真空度为正。 当压力继续升高时,保养指示器将会通过盖进行指示。 保养指示器指示需要更换烟雾处理滤清器。 使用下列步骤,进行保养指示器复位:
复位保养指示器
- 拆下塑料盖。
Show/hide table
图 3 | g01292899 |
(4) 塑料盖 (5) 保养指示灯 |
- 在保养指示灯上下推
- 更换塑料盖。
更换烟雾处理滤清器
Show/hide table
热油和热的部件可能会导致人员受伤。 不要让热的油和部件接触皮肤。 |
注: 可能的话,在关闭发动机的同时进行保养。
- 松开将碳罐固定在滤清器座组件上的卡销。
Show/hide table
图 4 | g01938796 |
(6) 滤清器座组件 (7) 卡销 (8) 碳罐 |
- 降下碳罐,以便露出滤芯。 碳罐底部可能会有机油。 避免机油溅出。
注: 发动机运转过程中可能很难拆卸碳罐。 发动机运转过程中碳罐有负气压。 这会产生真空度。
- 向下拉滤芯,卸下滤芯。 妥善处理旧滤芯。
- 卸下旧滤芯顶端盖上的 O 形密封圈组件。
- 更换滤清器座组件底部的 O 形密封圈。
- 将新的 O 形密封圈安装在滤芯顶端盖上。 将滤芯安装到正确的位置。
- 更换碳罐,对准碳罐与滤清器座组件上的凸台。
- 将卡销夹紧在闭合位置。
Caterpillar Information System:
Reuse and Salvage for 3044, 3046, 3064, 3066, 3400, 3500, and C175 Engine Oil Pumps {1304, 1315} Reuse and Salvage for 3044, 3046, 3064, 3066, 3400, 3500, and C175 Engine Oil Pumps {1304, 1315}
3508B, 3512B, 3516B, 3512C and and 3516C Auxiliary Engines, Generator Set Engines, and Generator Sets Voltage Regulator Options
C18 Marine Auxiliary Engine Configuration Parameters
3412, 3412C, and 3412E Generator Set Engines Engine Speed - Test
Exhaust Gas Leakage in Certain 3516B Marine Engines{1050} Exhaust Gas Leakage in Certain 3516B Marine Engines{1050}
G3500B Engines Electrical Power Supply - Test
Leaks In The Filter Housing{3004, 3067} Leaks In The Filter Housing{3004, 3067}
C4.4 Generator Set Engines Ignition Keyswitch Circuit and Battery Supply Circuit - Test
G3304 and G3306 Engines Crankshaft
374F Excavator Seat
C11 and C13 Engines Engine Oil Filter Base
C13, C15, and C18 Tier 4 Final Engines Camshaft
3500 Generator Sets Generator Start-up Checklist
3412, 3412C, and 3412E Generator Set Engines Sensor Supply - Test
TH31-C9I, TH31-C9P, TH31-C9T, TH35-C11I, TH35-C13I, TH35-C13T, TH35-C15I and TH35-C15T Petroleum Power Train Packages and TH31-E61 and TH35-E81 Petroleum Transmissions Power Train Electronic Control System Connector Locations
C18 Marine Generator Set Cooling System Coolant (DEAC) - Change
C18 Marine Generator Set Cooling System Coolant (ELC) - Change
C18 Marine Engines Aftercooler Condensate Drain Valve - Inspect/Clean
2008/09/22 The Wiper Motor Has Been Improved {7305}
2008/09/15 A New Exhaust Elbow Is Used {1059}
UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Air Filter Element - Clean/Replace
UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Battery - Replace
UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Flywheel - Clean
UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Oil - Change