C1.1, C1.5 and C2.2 Generator Sets Caterpillar


Cooling System

Usage:

C1.1DE9.5 GB8
The coolant system contains the following components:

  • Radiator

  • Pressure cap for the radiator

  • Fan for the radiator

  • Drive pulley (if equipped) for the fan

  • Water pump

  • Drive pulley for the water pump

  • Water temperature regulator

  • Housing for the water temperature regulator

  • Coolant temperature switch

The coolant flows from the bottom of the radiator to the centrifugal water pump. The water pump is installed on the cylinder block above the timing case. The water pump is driven by a pulley. The crankshaft pulley turns a belt which drives the pulley of the water pump.

The water pump forces the coolant to flow to the water temperature regulator. When the engine is cold, the water temperature regulator is closed. Then, the coolant flows directly into the cylinder head. When the engine warms, the water temperature regulator begins to open. Then, the regulator allows some of the coolant to flow to the top of the radiator.

The regulator opens fully when the engine reaches the normal operating temperature. When the regulator is fully open, the flow to the radiator is the maximum. However, the regulator does not close the flow of coolant into the cylinder head.

Coolant flows continuously through the cylinder head and the top of the cylinder block. This coolant flows into the back of the water pump from the cylinder block. This coolant then mixes with the coolant that is pumped from the radiator by the water pump.

The water temperature regulator maintains the correct engine temperature by adjusting the direct flow of coolant to the top of the radiator. The coolant is cooled by the radiator. Heat is removed from the coolant by cooler air which passes over the radiator fins. The fan causes a high volume of air to flow between the radiator fins in order to provide sufficient cooling. The coolant flows from the radiator through the bottom hose to the coolant pump.

The engine has a housing for the water temperature regulator. The housing is installed on the left side of the cylinder head.

The water temperature regulator housing for all engine models is mounted vertically.

Caterpillar Information System:

C1.1, C1.5 and C2.2 Generator Sets General Information
3512C Engine for 785D Off-Highway Truck/Tractors Alternator and Regulator
C18 Generator Set Engines Switch Circuits - Test
C18 Generator Set Engines Speed/Timing - Test
C18 Generator Set Engines Speed Control (Switch) - Test
PM3516 Power Modules Product Description
C6.6 Marine Generator Set Sensors and Electrical Components - MCS Switches and Alarms
The Orientation of the Turbocharger Coolant Hose May Cause Coolant to Leak on Some 3500B Engines{1070, 1380} The Orientation of the Turbocharger Coolant Hose May Cause Coolant to Leak on Some 3500B Engines{1070, 1380}
C18 Generator Set Engines Sensor Supply - Test
C1.5 and C2.2 Generator Sets Electric Starting Motor
C1.5 and C2.2 Generator Sets Alternator and Regulator
C1.5 and C2.2 Generator Sets Crankshaft Pulley
C1.1, C1.5 and C2.2 Generator Sets Basic Engine
C1.1, C1.5 and C2.2 Generator Sets Electrical System
C1.1, C1.5 and C2.2 Generator Sets Fuel Injection Timing - Check
C1.1, C1.5 and C2.2 Generator Sets Engine Valve Lash - Inspect/Adjust
C1.1, C1.5 and C2.2 Generator Sets Cylinder Head - Inspect
C6.6 Marine Generator Set Engine Air Cleaner Element - Clean/Replace
C1.1, C1.5 and C2.2 Generator Sets Glow Plugs - Test
2013/08/21 A New Knowledge Network Community is Active {1000, 1000, 1000}
3516B Generator Set Engines with Dynamic Gas Blending Diagnostic Capabilities
C6.6 Marine Generator Set Engine Oil and Filter - Change - Single Oil Filter
PM3516 Power Modules Cooling System Coolant (DEAC) - Change
PM3516 Power Modules Cooling System Coolant (ELC) - Change
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.