Alternator and Regulator
Show/hide table
 | |
| Illustration 1 | g03357069 |
Show/hide table
| Specification for 316-7251 Charging Alternator Gp | |||
| Item | Qty | Part | Specification Description |
| Load the battery with a carbon pile 4C-4911 Battery Load Tester in order to get the maximum alternator output. | |||
| 1 | 1 | 5S-7349 Bolt | (B-) terminal. Torque to 6.2 ± 0.6 N·m (54.9 ± 5.3 lb in). |
| 2 | 1 | 187-2034 Flange Nut | Torque to 102 ± 7 N·m (75 ± 5 lb ft). |
| 3 | 1 | 6V-8187 Nut | Use a 7/16 ring terminal for (B+) terminal. (B+) terminal. Torque to 6.2 ± 0.6 N·m (54.9 ± 5.3 lb in). |
| 4 | - | - | The peak voltage for (R) terminal must not be less than the output voltage for (B+) terminal. |
| 5 | - | - | Tighten the bolt to 88 ± 7 N·m (65 ± 5 lb ft). |
| 6 | 1 | 4B-2047 Nut | (D+) terminal. Torque to 2.25 ± 0.25 N·m (19.91 ± 2.21 lb in). |
| - | - | - | Voltage is 24 V. Amperage is 105 amp. Polarity is negative ground. Direction of rotation is either direction. |
| - | - | - | Alternator performance at 25 °C (77 °F): Minimum full load current at 5000 rpm is 105 amp. Minimum full load current at 2000 rpm is 39 amp. Output voltage is 28 ± 1 V. |
Caterpillar Information System:
C18 Generator Set Engines Switch Circuits - Test
C18 Generator Set Engines Speed/Timing - Test
C18 Generator Set Engines Speed Control (Switch) - Test
PM3516 Power Modules Product Description
C6.6 Marine Generator Set Sensors and Electrical Components - MCS Switches and Alarms
The Orientation of the Turbocharger Coolant Hose May Cause Coolant to Leak on Some 3500B Engines{1070, 1380} The Orientation of the Turbocharger Coolant Hose May Cause Coolant to Leak on Some 3500B Engines{1070, 1380}
C18 Generator Set Engines Sensor Supply - Test
C1.5 and C2.2 Generator Sets Electric Starting Motor
C1.5 and C2.2 Generator Sets Alternator and Regulator
C1.5 and C2.2 Generator Sets Crankshaft Pulley
C1.5 and C2.2 Generator Sets Flywheel Housing
C1.5 and C2.2 Generator Sets Gear Group (Front)
C1.1, C1.5 and C2.2 Generator Sets General Information
C1.1, C1.5 and C2.2 Generator Sets Cooling System
C1.1, C1.5 and C2.2 Generator Sets Basic Engine
C1.1, C1.5 and C2.2 Generator Sets Electrical System
C1.1, C1.5 and C2.2 Generator Sets Fuel Injection Timing - Check
C1.1, C1.5 and C2.2 Generator Sets Engine Valve Lash - Inspect/Adjust
C1.1, C1.5 and C2.2 Generator Sets Cylinder Head - Inspect
C6.6 Marine Generator Set Engine Air Cleaner Element - Clean/Replace
C1.1, C1.5 and C2.2 Generator Sets Glow Plugs - Test
2013/08/21 A New Knowledge Network Community is Active {1000, 1000, 1000}
3516B Generator Set Engines with Dynamic Gas Blending Diagnostic Capabilities
C6.6 Marine Generator Set Engine Oil and Filter - Change - Single Oil Filter