Secondary Speed Timing Sensor Harness Inspection on Certain C18 Engines {1408}
- Excavator
- 390F (S/N: MGF1-UP)
- Landfill Compactor
- 836K (S/N: TWZ1-UP)
- Off Highway Truck
- 772G (S/N: KEX1-UP)
- Track-Type Tractor
- D9T (S/N: TWG1-UP; RJS1-UP; REX1-UP)
- Wheel Loader
- 988K (S/N: TWX1-UP)
Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.
Problem
The secondary speed timing sensor has had vibration causing the connector to fatigue on the engine harness side.
Show/hide table
Illustration 1 | g06008557 |
Solution
To diagnose the problem, perform the steps prior to sensor replacement.
- Check the harness connection.
- Check the pins of the connector.
- Check the wire tie that is holding the pig tail of the sensor, since the tie may be too tight.
Caterpillar Information System:
An Additional Ride Control Accumulator is Now Available on Certain 988K Wheel Loaders {5004, 5054, 5057, 5066, 5077} An Additional Ride Control Accumulator is Now Available on Certain 988K Wheel Loaders {5004, 5054, 5057, 5066, 5077}
910K, 914K and 920K Compact Wheel Loaders Cooling System Coolant (ELC) - Change
An Improved Clip on the 421-7246 Hose As is now used on Certain D11T Track-Type Tractors {5068} An Improved Clip on the 421-7246 Hose As is now used on Certain D11T Track-Type Tractors {5068}
631K Wheel Tractor-Scraper Operator Controls
906K, 906M, 907K, 907M, 908K and 908M Compact Wheel Loader Machine Systems Piston Pump (Hydrostatic) - Assemble
906K, 906M, 907K, 907M, 908K and 908M Compact Wheel Loader Machine Systems Lift Arms - Remove and Install
D6 Track-Type Tractor Welding on Machines with Electronic Controls
Improved Powered Access System is Now Available for Certain Large Wheel Loaders and Large Wheel Dozers {7254, 7255, 7256} Improved Powered Access System is Now Available for Certain Large Wheel Loaders and Large Wheel Dozers {7254, 7255, 7256}
D7E Track-Type Tractor Power Train Systems ECM Swap - Test
D7E Track-Type Tractor Power Train Systems Wiring Harness (Short Circuit) - Test
D7E Track-Type Tractor Power Train Systems Wiring Harness (Open Circuit) - Test
D7E Track-Type Tractor Power Train Systems Switch Circuits - Test
910K, 914K and 920K Compact Wheel Loaders Fire Extinguisher Location
Caterpillar Machine Fluids Recommendations Reference Material
An Improved O-Ring Seal Is Now Used On Certain D8 Track-Type Tractor Angle Blade Tilt Cylinders {5104} An Improved O-Ring Seal Is Now Used On Certain D8 Track-Type Tractor Angle Blade Tilt Cylinders {5104}
910M, 914M, and 918M Compact Wheel Loaders Rated Load
910M, 914M, and 918M Compact Wheel Loaders Battery Disconnect Switch
844K Wheel Dozer and 990K Wheel Loader Power Train Output Transfer Gears - Disassemble
953K Track-Type Loader Machine Systems Pump Mounting - Remove and Install
906K, 906M, 907K, 907M, 908K and 908M Compact Wheel Loader Machine Systems Control Manifold - Remove and Install - (Differential Lock) (Hydraulic Lockout)
C2.4 Tier 4 Final Engines for Caterpillar Built Machines Inlet Manifold - Remove and Install
C175-16 Locomotive Engine Aftercooler Coolant Pressure Is Low
994K Large Wheel Loader Field Assembly Manual Automatic Lubrication - Install
C175-16 Locomotive Engine Aftercooler Coolant Temperature Is High