Illustration 1 | g00111768 |
NOTICE |
---|
Keep engine speed low until the engine oil pressure registers on the gauge or the engine oil indicator light goes out. If it does not register or the light go out within ten seconds, stop the engine and investigate the cause before starting again. Failure to do so, can cause engine damage. |
- Allow a cold engine to warm up at low idle for at least 5 minutes. Engage the implement controls and disengage the attachment controls in order to help warm-up of the hydraulic components.
Cycle all of the controls in order to allow the warm oil to circulate through all of the cylinders and all of the lines.
- All fault lights should turn off. The fault alarm should turn off. If the fault lights do not turn off, stop the engine. Make any necessary repairs before you start the engine.
Show/hide table
Illustration 2 g00456556 - Frequently look at the action light and the gauge display during operation.
- Look at the hydraulic oil tank and the transmission oil levels. Maintain the oil levels to the "FULL" marks.
If the jacket water coolant temperature is less than
Elevated low idle can be disabled by placing the transmisson in gear from Neutral or releasing the parking brake. Cold Mode may reactivate if the temperature conditions still exist and the transmission is not in gear. Cold Mode also varies the fuel injection amount and timing for limiting white smoke.