D6N Track-Type Tractor Caterpillar


Accumulator - Test and Charge - Power Train

Usage:

D6N P5S

------ WARNING! ------

在发动机停机后,液压系统或动力传动系的部件中将会依然存在高压下的热液压油。 液压油的未受控制的释放可能会导致机器的突然移动或造成以下情况:

  • 烧伤

  • 穿透人体组织

  • 其他人身伤害

  • 死亡

如果液压油穿透人体组织,必须立刻找熟悉这类创伤的医生来治疗。 请使用木板或硬纸板來检查液压油泄漏情况。 确保所有附件都已经降至地面上并且液压系统和动力传动系中的所有截留的压力都已经得到了释放。 此外,在拆卸任何部件或管路前,要确保液压油是冷的。 只有当发动机停机,而且加注口盖足够冷却,可以直接用手接触时,才可以拆卸液压油加注口盖。


------ WARNING! ------

未接合制动器会导致严重的人身伤害或死亡。

变速箱单独接合将不能阻止机器在发动机停机时发生翻滚。


------ WARNING! ------

干燥氮气是唯一被认可用来给蓄能器充气的气体。 对蓄能器充氧气会引起爆炸。 使用带有标准 CGA(压缩气体产业协会,Compressed Gas Association, Inc.) 580 号接头的氮气罐可避免发生爆炸。 订购氮气罐时,务必订购带有 CGA 580 号接头的氮气罐。

不要依赖颜色代码或其它标识方法来区别氮气罐与氧气罐。 在任何情况下,都不能用同一个适配器把充氮总成连接到氮气、氧气或其它气体罐共用的阀出口上。 确保使用的是干燥氮气(纯度 99.8%)。



注意

在检查、保养、测试、调整及维修产品时,请小心确保盛接油液。 在打开任何舱室或拆卸任何含有油液的部件前,请准备好盛接液体用的适当容器。


技术规格

表 1
不同机油温度时的蓄能器充注压力 
温度  压力 
16 °C (60 °F)  827 kPa (120 psi) 
21 °C (70 °F)  861 kPa (125 psi) 
26 °C (80 °F)  896 kPa (130 psi) 

简介

在低流量条件下,蓄能器补充动力传动系机油流量。 蓄能器位于推土机背面的外壳和机架上方。

以下步骤将确定动力传动系的蓄能器中是否充注了适当的压力。

测试准备

  1. 把机器开到平整水平的地方。

  2. 机器上仅允许停留一位操作员。 让其他所有人员远离机器或在操作员的视野范围内。

  3. 将转向操纵杆置于 NEUTRAL(空档)位置。

  4. 接合停车制动器。

  5. 将选装部件降到地面。

  6. 停止发动机。

  7. 将钥匙转到 ON (接通)位置,但不要起动发动机。

  8. 确认机具切断控制装置处于解锁位置。

  9. 在整个行程范围内移动操纵杆数次。 这样将释放可能存在于机具液压系统的任何压力。

  10. 松开液压油箱上的加注口盖,以便释放油箱中的压力。 该机器可能配备有断路器阀。 断路器阀位于油箱的顶部。 按下断路器阀(如有配备)顶部上的按钮,以便释放油箱内的压力。

  11. 拧紧液压油箱上的加注口盖。

  12. 确保整个液压系统内的压力都已被释放。

测试步骤

  1. 没有针对该蓄能器的车载测试步骤。

充压步骤



    图 1g03704623
    (1) 蓄能器
    (2) 阀盖
    (3) 阀


    图 2g03704633
    (1) 蓄能器
    (2) 阀盖
    (3) 阀

  1. 请参阅专门说明书, REHS5464, "蓄能器排放和充压步骤"。

Caterpillar Information System:

Cat® Command for Dozing, Operator Station Diagnostic Capabilities
® for Dozing, Semi-Autonomous Tractor System (SATS) and Operator Station Connector Locations
Cat® Command for Dozing, Operator Station Service Tools
Cat® Command for Dozing, Operator Station General Information
312D2 and 313D2 Excavators Machine System Window Wiper Delay - Test
525D, 535D, 545D and 555D Wheel Skidders Machine Systems Parking Brake - Test
D8T Track-Type Tractor Systems Lines (Hydraulic Fan)
D8T Track-Type Tractor Air Cleaner
D8T Track-Type Tractor Cab Window
C3.4B Engines Welding Precaution
D8T Track-Type Tractor Systems Pump Control Valve - Flow Compensator
D8T Track-Type Tractor Systems Pump Control Valve - Pressure Compensator
D8T Track-Type Tractor Systems Lines (Lift Cylinder)
2014/07/24 Cat® Reman Announces the Addition of 3126, 3176, and C9 Machine Engines {1000}
D8T Track-Type Tractor Systems Fender
312D2 and 313D2 Excavators Machine Systems Gear Pump (Pilot) - Test
D8T Track-Type Tractor Systems Pump Lines
950M and 962M Wheel Loaders Power Train, Steering, Braking, Hydraulic, and Machine Systems General Information (Hydraulic System)
D3K2, D4K2 and D5K2 Track-Type Tractor Systems Location of Components (Power Train System)
2014/11/17 New Special Instructions , "Instructions For Replacing The Air Cleaner Group On Certain 627H Wheel Tractor-Scrapers" Are Now Available {1051, 1054}
D7E Track-Type Tractor Speed Sensor - Test - Motor Speed Sensor
2014/07/24 An Improved Pressure Sensor is Used on Wheel Skidders Equipped with Secondary Steering {1408, 1439, 4304}
D6N Track-Type Tractor Piston Pump (Implement) - Test and Adjust
826K Landfill Compactor, 825K Soil Compactor and 824K Wheel Dozer Engine Supplement Water Pump - Remove and Install
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.