Fuel Control Manifold (ARD) - Install
Installation Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Position fuel manifold (5) and install bolts (6) .
Show/hide table
 | |
| Illustration 1 | g01360842 |
- Install tube assemblies (7) .
- Install clamp assembly (3) .
- Connect harness assemblies (4) .
- Position bracket assembly (2) and install nuts (1) .
Caterpillar Information System:
C9 Agricultural Engine for Challenger Tractors Diagnostic Trouble Code List
C4.4 Engines for Caterpillar Built Machines Starter Motor
C4.4 Engines for Caterpillar Built Machines Alternator
C4.4 Engines for Caterpillar Built Machines Belt Tension Chart
C3.4 IND Industrial Engine Battery or Battery Cable - Disconnect
C4.4 Engines for Caterpillar Built Machines Crankshaft Pulley
C4.4 (Mech) Industrial Engine Plate Locations and Film Locations
C32 Marine and Auxiliary Marine Engines Fuel Filter Base
C9 On-highway Engine Fuel Control Manifold (ARD) - Remove
C9 Agricultural Engine for Challenger Tractors Configuration Parameters
CX28 On-Highway Transmission Speed Sensor (Transmission) - Remove and Install
C4.4 Engines for Caterpillar Built Machines Crankcase Breather
C4.4 (Mech) Industrial Engine Emissions Certification Film
C3.4 IND Industrial Engine Engine Oil and Filter - Change
C9 On-highway Engine Fuel Transfer Pump - Remove
345D, 349D and 349D2 Excavator Machine System Specifications Relief Valve (Crossover)
C9 Agricultural Engine for Challenger Tractors Electronic Service Tools
CX35 On-Highway Transmission Maintenance Log
C9 On-highway Engine Fuel Transfer Pump - Install
3176C Engine for Caterpillar Built Machines Cylinder Is Noisy
C9 Agricultural Engine for Challenger Tractors Engine Cranks but Does Not Start
C32 Marine Engines Fuel Priming Pump - Remove and Install
Starting Motor - Delco 50-MT Component Description
Starting Motor - Delco 50-MT General Information