Fuel Transfer Pump - Install
Installation Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Position fuel transfer pump (8) .
Show/hide table
 | |
| Illustration 1 | g01361067 |
- Install studs (9) and install bolts (7). Torque studs (9) and bolts (7) to 30 ± 4 N·m (22 ± 3 lb ft).
- Position bracket (5) and install nut (6) .
Show/hide table
 | |
| Illustration 2 | g01361043 |
- Install bolts (1) .
- Position bracket (4) .
- Install nuts (2) and (3) .
End By: Install the fuel manifold. Refer to Disassembly and Assembly, "Fuel Control Manifold (ARD) - Install".
Caterpillar Information System:
CX35 On-Highway Transmission Maintenance Log
C9 Agricultural Engine for Challenger Tractors Electronic Service Tools
345D, 349D and 349D2 Excavator Machine System Specifications Relief Valve (Crossover)
C9 On-highway Engine Fuel Transfer Pump - Remove
C3.4 IND Industrial Engine Engine Oil and Filter - Change
C4.4 (Mech) Industrial Engine Emissions Certification Film
C9 On-highway Engine Fuel Control Manifold (ARD) - Install
C9 Agricultural Engine for Challenger Tractors Diagnostic Trouble Code List
C4.4 Engines for Caterpillar Built Machines Starter Motor
C4.4 Engines for Caterpillar Built Machines Alternator
C4.4 Engines for Caterpillar Built Machines Belt Tension Chart
C3.4 IND Industrial Engine Battery or Battery Cable - Disconnect
3176C Engine for Caterpillar Built Machines Cylinder Is Noisy
C9 Agricultural Engine for Challenger Tractors Engine Cranks but Does Not Start
C32 Marine Engines Fuel Priming Pump - Remove and Install
Starting Motor - Delco 50-MT Component Description
Starting Motor - Delco 50-MT General Information
C9 On-highway Engine Cylinder Block Cover - Remove and Install
Starting Motor - Delco 50-MT General Information
Starting Motor - Delco 50-MT Service Tools
Starting Motor - Delco 50-MT Pinion Does Not Engage Ring Gear
Starting Motor - Delco 50-MT Engine Does Not Crank with Starting Motor On and Pinion Engaging Ring Gear
Starting Motor - Delco 50-MT Starting Motor Continues to Operate after Start Switch Has Been Released
Starting Motor - Delco 50-MT Pinion Continues to Engage after Engine Starts