Cylinder Block Cover - Remove and Install
Removal Procedure
Start By:
- Remove the engine control module. Refer to Disassembly and Assembly, "Engine Control Module - Remove and Install".
- Remove the fuel manifold. Refer to Disassembly and Assembly, "Fuel Control Manifold (ARD) - Remove".
- Disconnect tube assembly (1) and disconnect harness assembly (2) .
Show/hide table
Illustration 1 | g01361204 |
- Remove bolt (3) .
Show/hide table
Illustration 2 | g01361219 |
- Remove nut (5) and remove bracket (4) .
- Remove bolts (6) and remove cover (7) .
Show/hide table
Illustration 3 | g01361237 |
Installation Procedure
Show/hide table
NOTICE |
---|
Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. |
Show/hide table
NOTICE |
---|
Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary. |
- Position cover (7) and install bolts (6) .
Show/hide table
Illustration 4 | g01361237 |
- Position bracket (4) and install nut (5) .
Show/hide table
Illustration 5 | g01361219 |
- Install bolt (3) .
- Connect tube assembly (1) and connect harness assembly (2) .
Show/hide table
Illustration 6 | g01361204 |
End By:
- Install the fuel manifold. Refer to Disassembly and Assembly, "Fuel Control Manifold (ARD) - Install".
- Install the engine control module. Refer to Disassembly and Assembly, "Engine Control Module - Remove and Install".
Caterpillar Information System:
Starting Motor - Delco 50-MT General Information
Starting Motor - Delco 50-MT Component Description
C32 Marine Engines Fuel Priming Pump - Remove and Install
C9 Agricultural Engine for Challenger Tractors Engine Cranks but Does Not Start
3176C Engine for Caterpillar Built Machines Cylinder Is Noisy
C9 On-highway Engine Fuel Transfer Pump - Install
CX35 On-Highway Transmission Maintenance Log
C9 Agricultural Engine for Challenger Tractors Electronic Service Tools
345D, 349D and 349D2 Excavator Machine System Specifications Relief Valve (Crossover)
C9 On-highway Engine Fuel Transfer Pump - Remove
C3.4 IND Industrial Engine Engine Oil and Filter - Change
C4.4 (Mech) Industrial Engine Emissions Certification Film
Starting Motor - Delco 50-MT General Information
Starting Motor - Delco 50-MT Service Tools
Starting Motor - Delco 50-MT Pinion Does Not Engage Ring Gear
Starting Motor - Delco 50-MT Engine Does Not Crank with Starting Motor On and Pinion Engaging Ring Gear
Starting Motor - Delco 50-MT Starting Motor Continues to Operate after Start Switch Has Been Released
Starting Motor - Delco 50-MT Pinion Continues to Engage after Engine Starts
Starting Motor - Delco 50-MT Starting Motor Solenoid - Test
Starting Motor - Delco 50-MT Field Winding - Test
Starting Motor - Delco 50-MT Armature - Test
345D, 349D and 349D2 Excavator Machine System Specifications Stick Cylinder Lines - Stick Lowering Control
Starting Motor - Delco 50-MT Brush and Brush Holder - Check
Starting Motor - Delco 50-MT Pinion Drive - Check