Engine Oil Filter Base and Oil Cooler - Assemble
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 9S-3263 | Thread Lock Compound | 1 |
- Apply Tooling (A) to the base end of stud (6). Install stud (6). Tighten stud (6) to a torque of
68 ± 7 N·m (50 ± 5 lb ft) .Note: Check the O-ring seals for wear or for damage. If necessary, replace the O-ring seals.
- Install valve (5). Install spring (7). Install O-ring seal (8) onto plug (9). Install plug (9).
- Install valve (4). Install spring (3). Install O-ring seal (2) onto plug (1). Install plug (1).
Show/hide table
Illustration 1 | g01258209 |
Show/hide table
Improper assembly of parts that are spring loaded can cause bodily injury. To prevent possible injury, follow the established assembly procedure and wear protective equipment. |
End By:
- Install the engine oil filter base and the oil cooler. Refer to Disassembly and Assembly, "Engine Oil Filter Base and Oil Cooler - Install".
Caterpillar Information System:
3500B and 3500C Locomotive Engines Cat Data Link
C7 On-Highway Engine Engine Oil Filter Base and Oil Cooler - Disassemble
TH31-C9I, TH31-C9P, TH31-C9T, TH35-C13I, TH35-C13T, TH35-C15I and TH35-C15T Petroleum Power Train Packages and TH31-E61 and TH35-E81 Petroleum Transmissions Transmission Gear Pump (Transmission)
C9 Industrial Engines Jacket Water Heater
C9 Industrial Engines Jacket Water Heater
Inability to Flash ECM Software on Certain Generator Sets{7620} Inability to Flash ECM Software on Certain Generator Sets{7620}
C7 On-Highway Engine Engine Oil Filter Base and Oil Cooler - Install
C7 PETROLEUM Petroleum Engine Vibration Damper and Pulley - Remove and Install
C175 Generator Sets General Maintenance Information
3500B and 3500C Locomotive Engines CAN Data Link
2006/05/22 Improved Rectifier for Heat Sink Assembly {4465, 4472}
C9.3 Tier 4 Final Engines Coolant Temperature Sensor
C13 Tier 4 Final Engines Fuel Pressure Sensor
3500B and 3500C Locomotive Engines Electrical Power Supply
CX31 On-Highway Transmission Hydraulic Oil Contamination - Test
CX31 On-Highway Transmission Relief Valve (Torque Converter Inlet) Pressure - Test
CX31 On-Highway Transmission Relief Valve (Torque Converter Outlet) Pressure - Test and Adjust
C7 PETROLEUM Petroleum Engine Valve Mechanism Cover Base - Remove and Install
3500B and 3500C Locomotive Engines Emergency Stop Switch
C9 Industrial Engines Inlet Air Temperature Sensor
C7 On-highway Engine Air Inlet Cover
C7 On-Highway Engine Combustion Body - Remove and Install
3500B and 3500C Locomotive Engines Ether Injection System
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies System Startup (SMS) - Single Module System