Oil Filter and Base (Power Train) - Assemble
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
- Install springs (3) and (6). Install spool (2) and adapter (5). Install switch (1) to a torque of
80 ± 10 N·m (59 ± 7 lb ft) . - Install filter element (4), O-ring seal (7), and filter housing (8) and tighten to a torque of
55 ± 5 N·m (40.5 ± 3 lb ft) . Lubricate the O-ring seal with the lubricant that is being sealed.
Show/hide table
Illustration 1 | g01199925 |
Show/hide table
Improper assembly of parts that are spring loaded can cause bodily injury. To prevent possible injury, follow the established assembly procedure and wear protective equipment. |
End By:
- Install the Power Train oil filter. Refer to Disassembly and Assembly, "Power Train Oil Filter - Remove and Install".
Caterpillar Information System:
D7R Series II Track-Type Tractor Power Train Oil Filter and Base (Power Train) - Disassemble
AccuGrade® GPS (CD700) Glossary
AccuGrade® GPS (CD700) Troubleshooting Techniques
AccuGrade® GPS (CD700) End User License Agreement
AccuGrade® GPS (CD700) Machine Symbols
AccuGrade® GPS (CD700) Full Screen Messages
AccuGrade® GPS (CD700) Flashing Messages
AccuGrade® GPS (CD700) Common Problems
AccuGrade® GPS (CD700) General Maintenance Information
AccuGrade® GPS (CD700) Design Surface Type
AccuGrade® GPS (CD700) General Information
AccuGrade® GPS (CD700) Safety Messages
525C, 535C and 545C Wheel Skidders Power Train Parking Brake - Remove
525C, 535C and 545C Wheel Skidders Power Train Parking Brake - Install
D7R Series II Track-Type Tractor Power Train Oil Filter and Base (Power Train) - Install
525C, 535C and 545C Wheel Skidders Power Train Parking Brake Actuator - Remove
525C, 535C and 545C Wheel Skidders Power Train Parking Brake Actuator - Install
525C, 535C and 545C Wheel Skidders Power Train Torque Converter from Transmission - Separate
525C, 535C and 545C Wheel Skidders Power Train Torque Converter to Transmission - Connect
854K Wheel Dozer Hydraulic System Oil Level (Implement) (Hydraulic Fan) - Check
854K Wheel Dozer Hydraulic System Oil Level (Steering) (Brake) - Check
525C, 535C and 545C Wheel Skidders Power Train Bottom Guard (Engine) - Remove and Install
525C, 535C and 545C Wheel Skidders Power Train Bottom Guard (Transmission) - Remove and Install
854K Wheel Dozer Hydraulic Tank Breaker Relief Valve - Clean