Speed Sensor (Transmission) - Assemble
Assembly Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
- Install transmission speed sensors (7) .
Show/hide table
Illustration 1 | g01265282 |
- Install bearing (5). Install retaining ring (6) .
Show/hide table
Illustration 2 | g01265266 |
- Position rotor assembly (4) and install bolts (3).
Show/hide table
Illustration 3 | g01269723 |
- Install spacers (2) and spacer (1) .
End By: Install the transmission speed sensor. Refer to Disassembly and Assembly, "Speed Sensor (Transmission) - Install".
Caterpillar Information System:
D7R Series II Track-Type Tractor Machine Systems Piston Motor (Steering) - Assemble
C4.4 Industrial Engine Fuel Injection
D7R Series II Track-Type Tractor Machine Systems Piston Motor (Steering) - Disassemble
D11T, D8T and D9T Track-Type Tractors VIMSTM 3G / Product Link Electronic Control Module (ECM) - Replace
D7R Series II Track-Type Tractor Machine Systems Piston Motor (Steering) - Install
2006/04/24 Correction to Specification , "D3C, D4C and D5C Series III Hystat Track-Type Tractor Power" {4350}
D7R Series II Track-Type Tractor Machine Systems Piston Motor (Steering) - Remove
525C, 535C and 545C Wheel Skidders Power Train Transmission Pump Drive Housing - Install
525C, 535C and 545C Wheel Skidders Power Train Transmission Pump Drive Housing - Remove
D6G Series 2 Track-Type Tractor Power Train Brakes
938H Wheel Loader and IT38H Integrated Toolcarrier Steering System Secondary Steering Pump and Electric Motor
938H and IT38H Wheel Loader and Integrated Tool Carrier Power Train Transmission Oil Pump
The Breather Hole In 7T-7706 Housing As Is Not Drilled To the Correct Depth{3120} The Breather Hole In 7T-7706 Housing As Is Not Drilled To the Correct Depth{3120}
938H Wheel Loader and IT38H Integrated Toolcarrier Hydraulic System Control Manifold (Implement, Steering Pump Margin Relief)
D7G2 Track-Type Tractor Power Train Sequence Relief Valve
525C, 535C and 545C Wheel Skidders Machine Systems Piston Pump (Implement, Steering, Brake) - Disassemble
525C, 535C and 545C Wheel Skidders Machine Systems Piston Pump (Implement, Steering, Brake) - Assemble
631G and 637G Wheel Tractor-Scrapers Machine Systems Oil Filter (Hydraulic Tank) - Remove
631G and 637G Wheel Tractor-Scrapers Machine Systems Oil Filter (Hydraulic Tank) - Install
631G and 637G Wheel Tractor-Scrapers Machine Systems Oil Filter (Hydraulic Tank) - Disassemble
631G and 637G Wheel Tractor-Scrapers Machine Systems Oil Filter (Hydraulic Tank) - Assemble
938H Wheel Loader and IT38H Integrated Toolcarrier Steering System Piston Pump (Implement, Steering)
525C, 535C and 545C Wheel Skidders Machine Systems Gear Pump (Pilot) - Disassemble
525C, 535C and 545C Wheel Skidders Machine Systems Gear Pump (Pilot) - Assemble